Hi Abhishek, On 6/29/2017 12:45 PM, Abhishek Sahu wrote: > The configuration for BCH is not correct in the current > driver so this patch fixed the same. > > Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx> > --- > drivers/mtd/nand/qcom_nandc.c | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/drivers/mtd/nand/qcom_nandc.c b/drivers/mtd/nand/qcom_nandc.c > index 520add9..410ee53 100644 > --- a/drivers/mtd/nand/qcom_nandc.c > +++ b/drivers/mtd/nand/qcom_nandc.c > @@ -1919,7 +1919,7 @@ static int qcom_nand_host_setup(struct qcom_nand_host *host) > | wide_bus << WIDE_FLASH > | 1 << DEV0_CFG1_ECC_DISABLE; > > - host->ecc_bch_cfg = host->bch_enabled << ECC_CFG_ECC_DISABLE > + host->ecc_bch_cfg = !host->bch_enabled << ECC_CFG_ECC_DISABLE > | 0 << ECC_SW_RESET > | host->cw_data << ECC_NUM_DATA_BYTES > | 1 << ECC_FORCE_CLK_OPEN > This could be patch #1, so basically all fixes first and then support for bam after that. Regards, Sricharan -- "QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation --- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html