Enable pinctrl for ADTRG pin (PD31) for ADC hardware trigger support.
Signed-off-by: Eugen Hristev <eugen.hristev@xxxxxxxxxxxxx>
Acked-by: Ludovic Desroches <ludovic.desroches@xxxxxxxxxxxxx>
---
arch/arm/boot/dts/at91-sama5d2_xplained.dts | 16 +++++++++++++++-
1 file changed, 15 insertions(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/at91-sama5d2_xplained.dts b/arch/arm/boot/dts/at91-sama5d2_xplained.dts
index 0bef9e0..04754b1 100644
--- a/arch/arm/boot/dts/at91-sama5d2_xplained.dts
+++ b/arch/arm/boot/dts/at91-sama5d2_xplained.dts
@@ -303,7 +303,7 @@
vddana-supply = <&vdd_3v3_lp_reg>;
vref-supply = <&vdd_3v3_lp_reg>;
pinctrl-names = "default";
- pinctrl-0 = <&pinctrl_adc_default>;
+ pinctrl-0 = <&pinctrl_adc_default &pinctrl_adtrg_default>;
status = "okay";
};
@@ -322,6 +322,20 @@
bias-disable;
};
+ /*
+ * The ADTRG pin can work on any edge type.
+ * In here it's being pulled up, so need to
+ * connect it to ground to get an edge e.g.
+ * Trigger can be configured on falling, rise
+ * or any edge, and the pull-up can be changed
+ * to pull-down or left floating according to
+ * needs.
+ */
+ pinctrl_adtrg_default: adtrg_default {
+ pinmux = <PIN_PD31__ADTRG>;
+ bias-pull-up;
+ };
+
pinctrl_charger_chglev: charger_chglev {
pinmux = <PIN_PA12__GPIO>;
bias-disable;
--
2.7.4
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
