On Fri, 9 Jun 2017 10:07:17 +0300 Eugen Hristev <eugen.hristev@xxxxxxxxxxxxx> wrote: > Add property for the edge type of the hardware trigger pin ADTRG > > Signed-off-by: Eugen Hristev <eugen.hristev@xxxxxxxxxxxxx> Hi Eugen, CC the device tree maintainers and list for devicetree binding changes. I've added them. This one is unusual enough it will need and Ack from that direction (and I prefer to get them even for the trivial patches when Rob and Mark aren't too busy!) Jonathan > --- > Changes in v4: > - Modified bindings to be similar with interrupts > > Documentation/devicetree/bindings/iio/adc/at91-sama5d2_adc.txt | 6 ++++++ > 1 file changed, 6 insertions(+) > > diff --git a/Documentation/devicetree/bindings/iio/adc/at91-sama5d2_adc.txt b/Documentation/devicetree/bindings/iio/adc/at91-sama5d2_adc.txt > index 3223684..552e7a8 100644 > --- a/Documentation/devicetree/bindings/iio/adc/at91-sama5d2_adc.txt > +++ b/Documentation/devicetree/bindings/iio/adc/at91-sama5d2_adc.txt > @@ -11,6 +11,11 @@ Required properties: > - atmel,min-sample-rate-hz: Minimum sampling rate, it depends on SoC. > - atmel,max-sample-rate-hz: Maximum sampling rate, it depends on SoC. > - atmel,startup-time-ms: Startup time expressed in ms, it depends on SoC. > + - atmel,trigger-edge-type: One of possible edge types for the ADTRG hardware > + trigger pin. When the specific edge type is detected, the conversion will > + start. Possible values are rising, falling, or both. > + This property uses the IRQ edge types values: IRQ_TYPE_EDGE_RISING , > + IRQ_TYPE_EDGE_FALLING or IRQ_TYPE_EDGE_BOTH > > Example: > > @@ -25,4 +30,5 @@ adc: adc@fc030000 { > atmel,startup-time-ms = <4>; > vddana-supply = <&vdd_3v3_lp_reg>; > vref-supply = <&vdd_3v3_lp_reg>; > + atmel,trigger-edge-type = <IRQ_TYPE_EDGE_BOTH>; > } -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html