This patch implements the hardware triggers support and buffer management for sama5d2. The DT modifications ( [PATCH v4 1/4] ARM: dts: at91: sama5d2_xplained: enable ADTRG pin) are for demonstration purposes of the feature, setting the pinctrl for the ADC hw trigger pin,should go through at91 maintainers. As discussed on the mailing list, since we have a single external trigger namely the ADTRG, but three different possible edges that can trigger it, will have a single trigger in the IIO subsystem and three possible edges which can be selected from the device tree. Thus I created new bindings in the device tree for having the possible edge types for the ADTRG pin. The documentation for the bindings is in the patch [PATCH v4 2/4] Documentation: dt: iio: at91-sama5d2_adc: add adtrg trigger binding The modifications in the DT are in the patch [PATCH v4 3/4] ARM: dts: at91: sama5d2: add ADC hw trigger The new property must be set with the values from interrupt edge types, as this pin is effectively an internal interrupt. Changes in v4: - Modified bindings to be similar with interrupts - Used iio claim direct to make sure buffer is not enabled when someone might try to use a software triggered conversion Changes in v3: - No longer have all three possible triggers registered in the subsystem and available in the sysfs. Only registering one trigger, and the possible edge is being read from the device tree. In the device tree, any possible edge can be set. There are three already made nodes for each possible edge which can be selected. - Fixed a bug where software triggered conversion could be started even if the hardware trigger was enabled. - Preallocate enough space for the buffer, considering all the channels and timestamp Changes in v2: - Moved buffer allocation and freeing into the preenable and postdisable callbacks. We have a total of scan bytes that can vary a lot depending on each channel enabled at a certain point. - made the at91 trigger list part of state structure - made the iio trigger list preallocated in state structure - moved irq enabling/disabling into the try_reenable callback - on trigger disable must write disable registries as well - Modified trigger name length to 64 Eugen Hristev (4): ARM: dts: at91: sama5d2_xplained: enable ADTRG pin Documentation: dt: iio: at91-sama5d2_adc: add hw trigger edge binding ARM: dts: at91: sama5d2: add ADC hw trigger edge type iio: adc: at91-sama5d2_adc: add hw trigger and buffer support .../bindings/iio/adc/at91-sama5d2_adc.txt | 6 + arch/arm/boot/dts/at91-sama5d2_xplained.dts | 16 +- arch/arm/boot/dts/sama5d2.dtsi | 1 + drivers/iio/adc/at91-sama5d2_adc.c | 236 ++++++++++++++++++++- 4 files changed, 253 insertions(+), 6 deletions(-) -- 2.7.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
