On 5/18/2017 1:03 AM, Bjorn Andersson wrote:
On Mon 15 May 02:05 PDT 2017, Varadarajan Narayanan wrote:
On 5/14/2017 9:53 AM, Bjorn Andersson wrote:
On Thu 11 May 03:33 PDT 2017, Varadarajan Narayanan wrote:
On 5/11/2017 4:13 AM, Bjorn Andersson wrote:
On Thu 04 May 04:53 PDT 2017, Varadarajan Narayanan wrote:
[..]
+ msm_mux_qpic_pad4,
What are qpic_pad and qpic_pad0 through qpic_pad8? Different functions,
alternative muxings...?
This is for the NAND and LCD display. The pins listed are the 9 data pins.
Then you can describe them all as "qpic_pad" (or simply "qpic"?). (It's
possible to reference a partial group in the DTS, if that's necessary)
There are two sets of 9 pins, either of which can go to NAND or LCD.
Will rename qpic_pad as qpic_a and qpic_pad[0-8] as qpic_b.
Is that ok?
So you have NAND and LCD hardware muxed to either "a" or "b" and then
you mux either "a" or "b" out onto actual pins?
How is this first mux configured?
I think the a/b scheme sounds reasonable, if above is how it works.
Sorry, I was wrong. I had misread the documentation.
There are 18 pins. 15 pins are common between LCD and NAND. The QPIC
controller arbitrates between LCD and NAND. Of the remaining 4, 2 are
for NAND and 2 are for LCD exclusively. We plan to group the qpic pins
into 3 groups namely, qpic_common, qpic_nand and qpic_lcd. Is that ok?
Thanks
Varada
Regards,
Bjorn
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora
Forum, a Linux Foundation Collaborative Project
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html