This adds the devicetree bindings documentation for the LTC3651 battery charger.
Signed-off-by: Mike Looijmans <mike.looijmans@xxxxxxxx>
---
v2: Add "lltc," vendor prefix to gpios
Expand irq paragraph
.../bindings/power/supply/ltc3651-charger.txt | 27 ++++++++++++++++++++++
1 file changed, 27 insertions(+)
create mode 100644 Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt
diff --git a/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt b/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt
new file mode 100644
index 0000000..71f2840
--- /dev/null
+++ b/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt
@@ -0,0 +1,27 @@
+ltc3651-charger
+
+Required properties:
+ - compatible: "lltc,ltc3651-charger"
+ - lltc,acpr-gpios: Connect to ACPR output. See remark below.
+
+Optional properties:
+ - lltc,fault-gpios: Connect to FAULT output. See remark below.
+ - lltc,chrg-gpios: Connect to CHRG output. See remark below.
+
+The ltc3651 outputs are open-drain type and active low. The driver assumes the
+GPIO reports "active" when the output is asserted, so if the pins have been
+connected directly, the GPIO flags should be set to active low also.
+
+The driver will attempt to aquire interrupts for all GPIOs to detect changes in
+line state. If the system is not capabale of providing interrupts, the driver
+cannot report changes and userspace will need to periodically read the sysfs
+attributes to detect changes.
+
+Example:
+
+ charger: battery-charger {
+ compatible = "lltc,ltc3651-charger";
+ lltc,acpr-gpios = <&gpio0 68 GPIO_ACTIVE_LOW>;
+ lltc,fault-gpios = <&gpio0 64 GPIO_ACTIVE_LOW>;
+ lltc,chrg-gpios = <&gpio0 63 GPIO_ACTIVE_LOW>;
+ };
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
