This adds documentation of device tree bindings for the STM32 DCMI (Digital Camera Memory Interface). Signed-off-by: Hugues Fruchet <hugues.fruchet@xxxxxx> --- .../devicetree/bindings/media/st,stm32-dcmi.txt | 46 ++++++++++++++++++++++ 1 file changed, 46 insertions(+) create mode 100644 Documentation/devicetree/bindings/media/st,stm32-dcmi.txt diff --git a/Documentation/devicetree/bindings/media/st,stm32-dcmi.txt b/Documentation/devicetree/bindings/media/st,stm32-dcmi.txt new file mode 100644 index 0000000..c0f6f4b --- /dev/null +++ b/Documentation/devicetree/bindings/media/st,stm32-dcmi.txt @@ -0,0 +1,46 @@ +STMicroelectronics STM32 Digital Camera Memory Interface (DCMI) + +Required properties: +- compatible: "st,stm32-dcmi" +- reg: physical base address and length of the registers set for the device +- interrupts: should contain IRQ line for the DCMI +- resets: reference to a reset controller, + see Documentation/devicetree/bindings/reset/st,stm32-rcc.txt +- clocks: list of clock specifiers, corresponding to entries in + the clock-names property +- clock-names: must contain "mclk", which is the DCMI peripherial clock +- pinctrl: the pincontrol settings to configure muxing properly + for pins that connect to DCMI device. + See Documentation/devicetree/bindings/pinctrl/st,stm32-pinctrl.txt. +- dmas: phandle to DMA controller node, + see Documentation/devicetree/bindings/dma/stm32-dma.txt +- dma-names: must contain "tx", which is the transmit channel from DCMI to DMA + +DCMI supports a single port node with parallel bus. It should contain one +'port' child node with child 'endpoint' node. Please refer to the bindings +defined in Documentation/devicetree/bindings/media/video-interfaces.txt. + +Example: + + dcmi: dcmi@50050000 { + compatible = "st,stm32-dcmi"; + reg = <0x50050000 0x400>; + interrupts = <78>; + resets = <&rcc STM32F4_AHB2_RESET(DCMI)>; + clocks = <&rcc 0 STM32F4_AHB2_CLOCK(DCMI)>; + clock-names = "mclk"; + pinctrl-names = "default"; + pinctrl-0 = <&dcmi_pins>; + dmas = <&dma2 1 1 0x414 0x3>; + dma-names = "tx"; + port { + dcmi_0: endpoint@0 { + remote-endpoint = <...>; + bus-width = <8>; + hsync-active = <0>; + vsync-active = <0>; + pclk-sample = <1>; + }; + }; + }; + -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html