In order to aid post-mortem debugging the Qualcomm platforms provides a
"memory download mode", where the boot loader will provide an interface
for custom tools to "download" the content of RAM to a host machine.
The mode is triggered by writing a magic value somehwere in RAM, that is
read in the boot code path after a warm-restart. Two mechanism for
setting this magic value are supported in modern platforms; a direct SCM
call to enable the mode or through a secure io write of a magic value.
In order for a normal reboot not to trigger "download mode" the magic
must be cleared during a clean reboot.
Download mode has to be enabled by including qcom_scm.download_mode=1 on
the command line.
Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
---
.../devicetree/bindings/firmware/qcom,scm.txt | 1 +
drivers/firmware/qcom_scm-32.c | 6 ++++
drivers/firmware/qcom_scm-64.c | 16 +++++++++
drivers/firmware/qcom_scm.c | 42 ++++++++++++++++++++++
drivers/firmware/qcom_scm.h | 2 ++
5 files changed, 67 insertions(+)
diff --git a/Documentation/devicetree/bindings/firmware/qcom,scm.txt b/Documentation/devicetree/bindings/firmware/qcom,scm.txt
index 20f26fbce875..8467a181f22c 100644
--- a/Documentation/devicetree/bindings/firmware/qcom,scm.txt
+++ b/Documentation/devicetree/bindings/firmware/qcom,scm.txt
@@ -18,6 +18,7 @@ Required properties:
* Core, iface, and bus clocks required for "qcom,scm"
- clock-names: Must contain "core" for the core clock, "iface" for the interface
clock and "bus" for the bus clock per the requirements of the compatible.
+- qcom,dload-mode-addr: Specifies the address for the download mode magic (optional)
Example for MSM8916:
diff --git a/drivers/firmware/qcom_scm-32.c b/drivers/firmware/qcom_scm-32.c
index 4284745e5516..f944dae950ad 100644
--- a/drivers/firmware/qcom_scm-32.c
+++ b/drivers/firmware/qcom_scm-32.c
@@ -561,6 +561,12 @@ int __qcom_scm_pas_mss_reset(struct device *dev, bool reset)
return ret ? : le32_to_cpu(out);
}
+int __qcom_scm_set_dload_mode(struct device *dev, bool enable)
+{
+ return qcom_scm_call_atomic2(QCOM_SCM_SVC_BOOT, QCOM_SCM_SET_DLOAD_MODE,
+ enable ? QCOM_SCM_SET_DLOAD_MODE : 0, 0);
+}
+
int __qcom_scm_set_remote_state(struct device *dev, u32 state, u32 id)
{
struct {
diff --git a/drivers/firmware/qcom_scm-64.c b/drivers/firmware/qcom_scm-64.c
index eb92e67e9e41..9d7c37577be3 100644
--- a/drivers/firmware/qcom_scm-64.c
+++ b/drivers/firmware/qcom_scm-64.c
@@ -382,6 +382,22 @@ int __qcom_scm_set_remote_state(struct device *dev, u32 state, u32 id)
return ret ? : res.a1;
}
+int __qcom_scm_set_dload_mode(struct device *dev, bool enable)
+{
+ struct qcom_scm_desc desc = {0};
+ struct arm_smccc_res res;
+ int ret;
+
+ desc.args[0] = QCOM_SCM_SET_DLOAD_MODE;
+ desc.args[1] = enable ? QCOM_SCM_SET_DLOAD_MODE : 0;
+ desc.arginfo = QCOM_SCM_ARGS(2);
+
+ ret = qcom_scm_call(dev, QCOM_SCM_SVC_BOOT, QCOM_SCM_SET_DLOAD_MODE,
+ &desc, &res);
+
+ return ret ? : res.a0;
+}
+
int __qcom_scm_io_readl(struct device *dev, phys_addr_t addr)
{
struct qcom_scm_desc desc = {0};
diff --git a/drivers/firmware/qcom_scm.c b/drivers/firmware/qcom_scm.c
index 7a443e3afb6a..a1632002c67c 100644
--- a/drivers/firmware/qcom_scm.c
+++ b/drivers/firmware/qcom_scm.c
@@ -19,6 +19,7 @@
#include <linux/cpumask.h>
#include <linux/export.h>
#include <linux/dma-mapping.h>
+#include <linux/module.h>
#include <linux/types.h>
#include <linux/qcom_scm.h>
#include <linux/of.h>
@@ -28,6 +29,9 @@
#include "qcom_scm.h"
+static bool download_mode;
+module_param(download_mode, bool, 0);
+
#define SCM_HAS_CORE_CLK BIT(0)
#define SCM_HAS_IFACE_CLK BIT(1)
#define SCM_HAS_BUS_CLK BIT(2)
@@ -38,6 +42,8 @@ struct qcom_scm {
struct clk *iface_clk;
struct clk *bus_clk;
struct reset_controller_dev reset;
+
+ phys_addr_t dload_mode_addr;
};
static struct qcom_scm *__scm;
@@ -327,6 +333,27 @@ int qcom_scm_io_writel(phys_addr_t addr, unsigned int val)
}
EXPORT_SYMBOL(qcom_scm_io_writel);
+static void qcom_scm_set_download_mode(bool enable)
+{
+ bool avail;
+ int ret;
+
+ avail = __qcom_scm_is_call_available(__scm->dev,
+ QCOM_SCM_SVC_BOOT,
+ QCOM_SCM_SET_DLOAD_MODE);
+ if (avail) {
+ ret = __qcom_scm_set_dload_mode(__scm->dev, enable);
+ if (ret)
+ dev_err(__scm->dev, "SCM failed to set download mode: %d\n", ret);
+ } else if (__scm->dload_mode_addr) {
+ ret = __qcom_scm_io_writel(__scm->dev, enable ? QCOM_SCM_SET_DLOAD_MODE : 0, 0x7b3000);
+ if (ret)
+ dev_err(__scm->dev, "SCM failed to set download mode: %d\n", ret);
+ } else {
+ dev_err(__scm->dev, "No available mechanism for setting download mode\n");
+ }
+}
+
/**
* qcom_scm_is_available() - Checks if SCM is available
*/
@@ -347,6 +374,7 @@ static int qcom_scm_probe(struct platform_device *pdev)
struct qcom_scm *scm;
unsigned long clks;
int ret;
+ u64 val;
scm = devm_kzalloc(&pdev->dev, sizeof(*scm), GFP_KERNEL);
if (!scm)
@@ -400,9 +428,22 @@ static int qcom_scm_probe(struct platform_device *pdev)
__qcom_scm_init();
+ ret = of_property_read_u64(pdev->dev.of_node, "qcom,dload-mode-addr", &val);
+ if (!ret)
+ scm->dload_mode_addr = val;
+
+ if (download_mode)
+ qcom_scm_set_download_mode(true);
+
return 0;
}
+void qcom_scm_shutdown(struct platform_device *pdev)
+{
+ if (download_mode)
+ qcom_scm_set_download_mode(false);
+}
+
static const struct of_device_id qcom_scm_dt_match[] = {
{ .compatible = "qcom,scm-apq8064",
/* FIXME: This should have .data = (void *) SCM_HAS_CORE_CLK */
@@ -430,6 +471,7 @@ static struct platform_driver qcom_scm_driver = {
.of_match_table = qcom_scm_dt_match,
},
.probe = qcom_scm_probe,
+ .shutdown = qcom_scm_shutdown,
};
static int __init qcom_scm_init(void)
diff --git a/drivers/firmware/qcom_scm.h b/drivers/firmware/qcom_scm.h
index 327d5e0a1ec3..1655810c1b2f 100644
--- a/drivers/firmware/qcom_scm.h
+++ b/drivers/firmware/qcom_scm.h
@@ -14,9 +14,11 @@
#define QCOM_SCM_SVC_BOOT 0x1
#define QCOM_SCM_BOOT_ADDR 0x1
+#define QCOM_SCM_SET_DLOAD_MODE 0x10
#define QCOM_SCM_BOOT_ADDR_MC 0x11
#define QCOM_SCM_SET_REMOTE_STATE 0xa
extern int __qcom_scm_set_remote_state(struct device *dev, u32 state, u32 id);
+extern int __qcom_scm_set_dload_mode(struct device *dev, bool enable);
#define QCOM_SCM_FLAG_HLOS 0x01
#define QCOM_SCM_FLAG_COLDBOOT_MC 0x02
--
2.12.0
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
