Hi Chris,
On Fri, Mar 17, 2017 at 2:41 PM, Chris Brandt <Chris.Brandt@xxxxxxxxxxx> wrote:
> On Friday, March 17, 2017, Geert Uytterhoeven wrote:
>> > On Friday, March 17, 2017, Geert Uytterhoeven wrote:
>> >> On Thu, Mar 16, 2017 at 6:51 PM, Chris Brandt
>> >> <chris.brandt@xxxxxxxxxxx>
>> >> wrote:
>> >> > +- clocks: the clock source for the RTC controller.
>> >>
>> >> The datasheet mentions 3 possible clock sources?
>> >
>> > There is the clock source that does the counting (RTC_X1, RTC_X3, XTAL),
>> and then a clock source that runs the register interface (run off of the
>> p0 clock). So I just need to turn on the p0 clock so I can get at the
>> registers. Note that if you do a hard reset with a RESET button, and all
>> the registers in the chip go back to their POR state, the counter still
>> counts off of the 32KHz XTAL even though the "peripheral clock" is stopped
>> (which just means you can't get to the registers).
>> >
>> > In reality, you have to assume the RTC counting source has already been
>> set up by u-boot, or from a past reboot, so I don't do any of that select
>> configuration at all.
>>
>> it would still be good to have phandles to the external clock sources as
>> well, as that describes the hardware topology.
>
> I'm confused, you mean make new clocks node for RTC_X1 (fixed at 32.768kHZ) and
> RTC_X3 (fixed at 4MHz), but then not really do anything with then? (the driver
You still do something with them, as they'll be linked from the rtc device node.
> doesn't need them)
The driver may use them in the future.
E.g. to select among X1, X3, or EXTAL, depending on availability.
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
