Hi Chris,
On Fri, Mar 17, 2017 at 2:16 PM, Chris Brandt <Chris.Brandt@xxxxxxxxxxx> wrote:
> Happy St Patrick's Day!
>
> (I know you are not Irish....but you are closer to Ireland than I am ;)
;-)
> On Friday, March 17, 2017, Geert Uytterhoeven wrote:
>> On Thu, Mar 16, 2017 at 6:51 PM, Chris Brandt <chris.brandt@xxxxxxxxxxx>
>> wrote:
>> > +- clocks: the clock source for the RTC controller.
>>
>> The datasheet mentions 3 possible clock sources?
>
> There is the clock source that does the counting (RTC_X1, RTC_X3, XTAL), and then a clock source that runs the register interface (run off of the p0 clock). So I just need to turn on the p0 clock so I can get at the registers. Note that if you do a hard reset with a RESET button, and all the registers in the chip go back to their POR state, the counter still counts off of the 32KHz XTAL even though the "peripheral clock" is stopped (which just means you can't get to the registers).
>
> In reality, you have to assume the RTC counting source has already been set up by u-boot, or from a past reboot, so I don't do any of that select configuration at all.
it would still be good to have phandles to the external clock sources as well,
as that describes the hardware topology.
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
