On Mon, Mar 13, 2017 at 3:27 AM, Michal Simek <michal.simek@xxxxxxxxxx> wrote: > Hi Moritz, > > On 10.3.2017 23:42, Moritz Fischer wrote: >> On Fri, Mar 10, 2017 at 1:30 PM, Moritz Fischer <mdf@xxxxxxxxxx> wrote: >>> This adds support for the Xilinx LogiCORE PR Decoupler >>> soft-ip that does decoupling of PR regions in the FPGA >>> fabric during partial reconfiguration. >>> >>> Signed-off-by: Moritz Fischer <mdf@xxxxxxxxxx> >>> Cc: Michal Simek <michal.simek@xxxxxxxxxx> >>> Cc: Sören Brinkmann <soren.brinkmann@xxxxxxxxxx> >>> Cc: linux-kernel@xxxxxxxxxxxxxxx >>> Cc: devicetree@xxxxxxxxxxxxxxx >>> --- >>> drivers/fpga/Kconfig | 9 +++ >>> drivers/fpga/Makefile | 1 + >>> drivers/fpga/xilinx-pr-decoupler.c | 156 +++++++++++++++++++++++++++++++++++++ >>> 3 files changed, 166 insertions(+) >>> create mode 100644 drivers/fpga/xilinx-pr-decoupler.c > > I have written very similar driver some week ago but didn't sent it out. Hah. I'll take a look. > Here it is. > https://github.com/Xilinx/linux-xlnx/blob/master/drivers/fpga/xilinx-pr-decoupler.c > > Your clk handling is better and my enable_show is better. > You shouldn't rely on setting status before. It is better to read that > reg again. The reason is you can connect status signal from one PR > decoupler to decouple input which can change status I will just merge them together and add you to author's list if that's fine with you? > There is another topic I wanted to open in connection to this. There > should be gpio based bridge because this pr decoupler can be without axi > interface and for that gpio driver would be useful. That's a good idea. I can look at that. This can be pretty generic code I suppose. Cheers, Moritz -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
