[PATCH v4 6/9] ARM64: dts: meson-gxbb-wetek-play2: add the ethernet PHY's reset GPIO

[Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>]

This resets the ethernet PHY during boot to get the PHY into a "clean"
state.
While here also specify the phy-handle of the ethmac node to make the
PHY configuration similar to the one we have on GXL devices. This will
allow us to specify OF-properties for the PHY itself.

Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>
Tested-by: Neil Armstrong <narmstrong@xxxxxxxxxxxx>
---
 .../boot/dts/amlogic/meson-gxbb-wetek-play2.dts    | 23 ++++++++++++++++++++++
 1 file changed, 23 insertions(+)

diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-wetek-play2.dts b/arch/arm64/boot/dts/amlogic/meson-gxbb-wetek-play2.dts
index ea79fdd2c248..c1392ed8dd4c 100644
--- a/arch/arm64/boot/dts/amlogic/meson-gxbb-wetek-play2.dts
+++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-wetek-play2.dts
@@ -87,6 +87,29 @@
 	};
 };
 
+&ethmac {
+	status = "okay";
+	pinctrl-0 = <&eth_rgmii_pins>;
+	pinctrl-names = "default";
+	phy-handle = <&eth_phy0>;
+	phy-mode = "rgmii";
+
+	snps,reset-gpio = <&gpio GPIOZ_14 0>;
+	snps,reset-delays-us = <0 10000 1000000>;
+	snps,reset-active-low;
+
+	mdio {
+		compatible = "snps,dwmac-mdio";
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		eth_phy0: ethernet-phy@0 {
+			/* Realtek RTL8211F (0x001cc916) */
+			reg = <0>;
+		};
+	};
+};
+
 &i2c_A {
 	status = "okay";
 	pinctrl-0 = <&i2c_a_pins>;
-- 
2.11.0

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html