This resets the ethernet PHY during boot to get the PHY into a "clean" state. While here also specify the phy-handle of the ethmac node to make the PHY configuration similar to the one we have on GXL devices. This will allow us to specify OF-properties for the PHY itself. Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> --- arch/arm64/boot/dts/amlogic/meson-gxbb-p200.dts | 24 ++++++++++++++++++++++++ 1 file changed, 24 insertions(+) diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-p200.dts b/arch/arm64/boot/dts/amlogic/meson-gxbb-p200.dts index 03e3d76626dd..fa0f84cfeaa9 100644 --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-p200.dts +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-p200.dts @@ -51,6 +51,30 @@ model = "Amlogic Meson GXBB P200 Development Board"; }; +ðmac { + status = "okay"; + pinctrl-0 = <ð_rgmii_pins>; + pinctrl-names = "default"; + phy-handle = <ð_phy0>; + phy-mode = "rgmii"; + + snps,reset-gpio = <&gpio GPIOZ_14 0>; + snps,reset-delays-us = <0 10000 1000000>; + snps,reset-active-low; + + mdio { + compatible = "snps,dwmac-mdio"; + #address-cells = <1>; + #size-cells = <0>; + + eth_phy0: ethernet-phy@0 { + compatible = "ethernet-phy-id0022.1620", + "ethernet-phy-ieee802.3-c22"; + reg = <3>; + }; + }; +}; + &i2c_B { status = "okay"; pinctrl-0 = <&i2c_b_pins>; -- 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html