On Thu, Jan 12, 2017 at 03:55:33AM +0800, Icenowy Zheng wrote: > > > 11.01.2017, 04:24, "Bin Liu" <b-liu@xxxxxx>: > > On Tue, Jan 03, 2017 at 11:25:34PM +0800, Icenowy Zheng wrote: > >> Lichee Pi Zero features a USB OTG port. > >> > >> Add support for it. > >> > >> Note: in order to use the Host mode, the board must be powered via the > >> +5V and GND pins. > >> > >> Signed-off-by: Icenowy Zheng <icenowy@xxxxxxxx> > >> --- > >> arch/arm/boot/dts/sun8i-v3s-licheepi-zero.dts | 10 ++++++++++ > >> 1 file changed, 10 insertions(+) > >> > >> diff --git a/arch/arm/boot/dts/sun8i-v3s-licheepi-zero.dts b/arch/arm/boot/dts/sun8i-v3s-licheepi-zero.dts > >> index 0099affc6ce3..3d9168cbaeca 100644 > >> --- a/arch/arm/boot/dts/sun8i-v3s-licheepi-zero.dts > >> +++ b/arch/arm/boot/dts/sun8i-v3s-licheepi-zero.dts > >> @@ -71,3 +71,13 @@ > >> pinctrl-names = "default"; > >> status = "okay"; > >> }; > >> + > >> +&usb_otg { > >> + dr_mode = "otg"; > > > > Why not set this default mode in dtsi instead? > > > > Regards, > > -Bin. > > There's possibly boards which do not have OTG functions. That is board specific. You'd better to define the default dr_mode which the musb _controller_ supports in the dtsi, and then override it in a specific board dts if necessary. Regards, -Bin. > > Even the official CDR design of V3s uses the USB controller to > connect a UVC webcam to make the design a dual-cam design > (V3s itself has a CSI). > > > > >> + status = "okay"; > >> +}; > >> + > >> +&usbphy { > >> + usb0_id_det-gpio = <&pio 5 6 GPIO_ACTIVE_HIGH>; > >> + status = "okay"; > >> +}; > >> -- > >> 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html