On 01/11/2017 06:39 PM, Andrzej Hajda wrote:
On 11.01.2017 09:40, Inki Dae wrote:
2017년 01월 11일 16:46에 Andrzej Hajda 이(가) 쓴 글:
On 11.01.2017 07:33, Hoegeun Kwon wrote:
From: Hyungwon Hwang <human.hwang@xxxxxxxxxxx>
This patch add the panel device tree node for S6E3HA2 display
controller to TM2 dts.
Signed-off-by: Hyungwon Hwang <human.hwang@xxxxxxxxxxx>
Signed-off-by: Andrzej Hajda <a.hajda@xxxxxxxxxxx>
Signed-off-by: Chanwoo Choi <cw00.choi@xxxxxxxxxxx>
Signed-off-by: Hoegeun Kwon <hoegeun.kwon@xxxxxxxxxxx>
Tested-by: Chanwoo Choi <cw00.choi@xxxxxxxxxxx>
---
arch/arm64/boot/dts/exynos/exynos5433-tm2.dts | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
index ddba2f8..6d362f9 100644
--- a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
+++ b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
@@ -18,6 +18,18 @@
compatible = "samsung,tm2", "samsung,exynos5433";
};
+&dsi {
+ panel@0 {
+ compatible = "samsung,s6e3ha2";
+ reg = <0>;
+ vdd3-supply = <&ldo27_reg>;
+ vci-supply = <&ldo28_reg>;
+ reset-gpios = <&gpg0 0 GPIO_ACTIVE_LOW>;
+ enable-gpios = <&gpf1 5 GPIO_ACTIVE_HIGH>;
+ te-gpios = <&gpf1 3 GPIO_ACTIVE_HIGH>;
The same here (as in 1st comment) , te-gpios should be dropper - decon
uses hw-trigger.
Reasonable to remove te-gpios property but this change would make MIPI-DSI driver probing to be failed so MIPI-DSI driver should be fixed together.
Thanks.
OK, I forgot it was not yet ported to mainline.
Regards
Andrzej
I received a reply while I was writing the mail.
so, how about removing te-gpios later?
Best Regards,
Hoegeun
Regards
Andrzej
+ };
+};
+
&hsi2c_9 {
status = "okay";
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
