This patch adds support for the "amcc,usb-otg" device which is found in the PowerPC Canyonlands' dts. The device definition was added by: commit c89b3458d8cc ("powerpc/44x: Add USB DWC DTS entry to Canyonlands board")' but without any driver support as the dwc2 driver wasn't available at that time. Note: The system can't use the generic "snps,dwc2" compatible because of the special ahbcfg configuration. The default GAHBCFG_HBSTLEN_INCR4 of snps,dwc2 can cause a system hang when the USB and SATA is used concurrently. Cc: Felipe Balbi <felipe.balbi@xxxxxxxxxxxxxxx> Cc: John Youn <johnyoun@xxxxxxxxxxxx> Signed-off-by: Christian Lamparter <chunkeey@xxxxxxxxx> --- v1->v2 - moved definitons to params.c - removed dma_enable / host_dma parameter - added dma_desc_fs_enable parameter --- Documentation/devicetree/bindings/usb/dwc2.txt | 1 + drivers/usb/dwc2/params.c | 33 ++++++++++++++++++++++++++ 2 files changed, 34 insertions(+) diff --git a/Documentation/devicetree/bindings/usb/dwc2.txt b/Documentation/devicetree/bindings/usb/dwc2.txt index 10a2a4b..6ccfe85 100644 --- a/Documentation/devicetree/bindings/usb/dwc2.txt +++ b/Documentation/devicetree/bindings/usb/dwc2.txt @@ -12,6 +12,7 @@ Required properties: - "lantiq,xrx200-usb": The DWC2 USB controller instance in Lantiq XRX SoCs; - "amlogic,meson8b-usb": The DWC2 USB controller instance in Amlogic Meson8b SoCs; - "amlogic,meson-gxbb-usb": The DWC2 USB controller instance in Amlogic S905 SoCs; + - "amcc,dwc-otg": The DWC2 USB controller instance in AMCC Canyonlands 460EX SoCs; - snps,dwc2: A generic DWC2 USB controller with default parameters. - reg : Should contain 1 register range (address and length) - interrupts : Should contain 1 interrupt diff --git a/drivers/usb/dwc2/params.c b/drivers/usb/dwc2/params.c index 64d5c66..5d822c5 100644 --- a/drivers/usb/dwc2/params.c +++ b/drivers/usb/dwc2/params.c @@ -192,6 +192,38 @@ static const struct dwc2_core_params params_amlogic = { .hibernation = -1, }; +static const struct dwc2_core_params params_amcc_dwc_otg = { + .otg_cap = DWC2_CAP_PARAM_HNP_SRP_CAPABLE, + .otg_ver = -1, + .dma_desc_enable = -1, + .dma_desc_fs_enable = -1, + .speed = -1, + .enable_dynamic_fifo = -1, + .en_multiple_tx_fifo = -1, + .host_rx_fifo_size = -1, + .host_nperio_tx_fifo_size = -1, + .host_perio_tx_fifo_size = -1, + .max_transfer_size = -1, + .max_packet_count = -1, + .host_channels = -1, + .phy_type = -1, + .phy_utmi_width = -1, + .phy_ulpi_ddr = -1, + .phy_ulpi_ext_vbus = -1, + .i2c_enable = -1, + .ulpi_fs_ls = -1, + .host_support_fs_ls_low_power = -1, + .host_ls_low_power_phy_clk = -1, + .ts_dline = -1, + .reload_ctl = -1, + /* Avoid system hang during concurrently using USB and SATA */ + .ahbcfg = GAHBCFG_HBSTLEN_INCR16 << + GAHBCFG_HBSTLEN_SHIFT, + .uframe_sched = -1, + .external_id_pin_ctl = -1, + .hibernation = -1, +}; + static const struct dwc2_core_params params_default = { .otg_cap = -1, .otg_ver = -1, @@ -239,6 +271,7 @@ const struct of_device_id dwc2_of_match_table[] = { { .compatible = "samsung,s3c6400-hsotg", .data = NULL}, { .compatible = "amlogic,meson8b-usb", .data = ¶ms_amlogic }, { .compatible = "amlogic,meson-gxbb-usb", .data = ¶ms_amlogic }, + { .compatible = "amcc,dwc-otg", .data = ¶ms_amcc_dwc_otg }, {}, }; MODULE_DEVICE_TABLE(of, dwc2_of_match_table); -- 2.10.2 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html