On Fri, Oct 07, 2016 at 06:17:29PM +0300, Pantelis Antoniou wrote:
> From: Georgi Vlaev <gvlaev@xxxxxxxxxxx>
>
> Add device tree bindings document for the GPIO driver of
> Juniper's PTXPMB/NGPMB CPLD.
>
> Signed-off-by: Georgi Vlaev <gvlaev@xxxxxxxxxxx>
> [Ported from Juniper kernel]
> Signed-off-by: Pantelis Antoniou <pantelis.antoniou@xxxxxxxxxxxx>
> ---
> .../bindings/gpio/jnx,gpio-ptxpmb-cpld.txt | 30 ++++++++++++++++++++++
> 1 file changed, 30 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-cpld.txt
>
> diff --git a/Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-cpld.txt b/Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-cpld.txt
> new file mode 100644
> index 0000000..1122021
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-cpld.txt
> @@ -0,0 +1,30 @@
> +Juniper PTXPMB CPLD GPIO block
> +
> +Required properties:
> +
> +- compatible:
> + Must be "jnx,gpio-ptxpmb-cpld"
> +
> +- #gpio-cells:
> + Should be <2>. The first cell is the pin number (within the controller's
> + pin space), and the second is used for the following flags:
> + bit[0]: direction (0 = out, 1 = in)
> + bit[1]: init high
> + bit[2]: active low
Use and/or add standard flags.
> +
> +- gpio-controller:
> + Specifies that the node is a GPIO controller.
> +
> +Optional properties:
> +
> +- reg:
> + Address and length of the register set for the device. Usually supplied by
> + the parent MFD driver
Make this mandatory.
> +
> +Example:
> +
> +gpio_cpld: cpld_gpio {
> + compatible = "jnx,gpio-ptxpmb-cpld";
> + #gpio-cells = <2>;
> + gpio-controller;
> +};
> --
> 1.9.1
>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
