From: Georgi Vlaev <gvlaev@xxxxxxxxxxx> Add device tree bindings document for the GPIO driver of Juniper's PTXPMB/NGPMB CPLD. Signed-off-by: Georgi Vlaev <gvlaev@xxxxxxxxxxx> [Ported from Juniper kernel] Signed-off-by: Pantelis Antoniou <pantelis.antoniou@xxxxxxxxxxxx> --- .../bindings/gpio/jnx,gpio-ptxpmb-cpld.txt | 30 ++++++++++++++++++++++ 1 file changed, 30 insertions(+) create mode 100644 Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-cpld.txt diff --git a/Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-cpld.txt b/Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-cpld.txt new file mode 100644 index 0000000..1122021 --- /dev/null +++ b/Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-cpld.txt @@ -0,0 +1,30 @@ +Juniper PTXPMB CPLD GPIO block + +Required properties: + +- compatible: + Must be "jnx,gpio-ptxpmb-cpld" + +- #gpio-cells: + Should be <2>. The first cell is the pin number (within the controller's + pin space), and the second is used for the following flags: + bit[0]: direction (0 = out, 1 = in) + bit[1]: init high + bit[2]: active low + +- gpio-controller: + Specifies that the node is a GPIO controller. + +Optional properties: + +- reg: + Address and length of the register set for the device. Usually supplied by + the parent MFD driver + +Example: + +gpio_cpld: cpld_gpio { + compatible = "jnx,gpio-ptxpmb-cpld"; + #gpio-cells = <2>; + gpio-controller; +}; -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html