From: Georgi Vlaev <gvlaev@xxxxxxxxxxx> Add device tree bindings document for the GPIO driver of Juniper's CBC FPGA. Signed-off-by: Georgi Vlaev <gvlaev@xxxxxxxxxxx> [Ported from Juniper kernel] Signed-off-by: Pantelis Antoniou <pantelis.antoniou@xxxxxxxxxxxx> --- .../devicetree/bindings/gpio/jnx,gpio-cbc.txt | 30 ++++++++++++++++++++++ 1 file changed, 30 insertions(+) create mode 100644 Documentation/devicetree/bindings/gpio/jnx,gpio-cbc.txt diff --git a/Documentation/devicetree/bindings/gpio/jnx,gpio-cbc.txt b/Documentation/devicetree/bindings/gpio/jnx,gpio-cbc.txt new file mode 100644 index 0000000..d205d0b --- /dev/null +++ b/Documentation/devicetree/bindings/gpio/jnx,gpio-cbc.txt @@ -0,0 +1,30 @@ +Juniper CBC FPGA GPIO block + +Required properties: + +- compatible: + Must be "jnx,cbc-gpio" + +Optional properties: + +- reg: + Address and length of the register set for the device. This is optional since + usually the parent MFD driver fills it in. + +- #gpio-cells: + Should be <2>. The first cell is the pin number (within the controller's + pin space), and the second is used for the following flags: + bit[0]: direction (0 = out, 1 = in) + bit[1]: init high + bit[2]: active low + +- gpio-controller: + Specifies that the node is a GPIO controller. + +Example: + +gpio_cbc { + compatible = "jnx,gpio-cbc"; + #gpio-cells = <2>; + gpio-controller; +}; -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html