Add the regulator supply properties needed by ADV7511 and ADV7533. The regulator names are named after the pin names, except for DVDD_3V on ADV7511, which is left v3p3 to have the same name as it's on ADV7533. ADV7511 has a BGVDD pin for which the voltage to be configured isn't clear. This needs to be updated in the document later. The regulators are specified as optional properties since there can be boards which have a fixed supply directly routed to the pins, and these may not be modelled as regulator supplies. Cc: Rob Herring <robh@xxxxxxxxxx> Cc: devicetree@xxxxxxxxxxxxxxx Signed-off-by: Archit Taneja <architt@xxxxxxxxxxxxxx> --- v2: - Specify regulator supplies for ADV7511 too. - Have separate supply entries for AVDD, DVDD, PVDD, A2VDD pins. - Add additional BGVDD supply for ADV7511. .../devicetree/bindings/display/bridge/adi,adv7511.txt | 14 ++++++++++++++ 1 file changed, 14 insertions(+) diff --git a/Documentation/devicetree/bindings/display/bridge/adi,adv7511.txt b/Documentation/devicetree/bindings/display/bridge/adi,adv7511.txt index 6532a59..66e6bae 100644 --- a/Documentation/devicetree/bindings/display/bridge/adi,adv7511.txt +++ b/Documentation/devicetree/bindings/display/bridge/adi,adv7511.txt @@ -56,6 +56,20 @@ Optional properties: - adi,disable-timing-generator: Only for ADV7533. Disables the internal timing generator. The chip will rely on the sync signals in the DSI data lanes, rather than generate its own timings for HDMI output. +- avdd-supply: A 1.8V supply that powers up the AVDD pin on the chip. +- dvdd-supply: A 1.8V supply that powers up the DVDD pin on the chip. +- pvdd-supply: A 1.8V supply that powers up the PVDD pin on the chip. +- v3p3-supply: A 3.3V supply that powers up the pin called DVDD_3V on + ADV7511 and V3P3 on ADV7533. + +ADV7511 specific supplies: +- bgvdd-supply: Powers the BGVDD pin. The voltage isn't clear from + available datasheets. + +ADV7533 specific supplies: +- a2vdd-supply: 1.8V supply that powers up the A2VDD pin on the chip. +- v1p2-supply: A supply that powers up the V1P2 pin on the chip. It can be + either 1.2V or 1.8V. Required nodes: -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, hosted by The Linux Foundation -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
