Kevin Hilman <khilman@xxxxxxxxxxxx> writes: > Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> writes: > >> From: Jerome Brunet <jbrunet@xxxxxxxxxxxx> >> >> Enable both gxbb USB controller and add a 5V regulator for the OTG port >> VBUS >> >> Signed-off-by: Jerome Brunet <jbrunet@xxxxxxxxxxxx> > > nit: subject should have "ARM64: dts:" prefix. > >> --- >> arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi | 29 ++++++++++++++++++++++++ >> 1 file changed, 29 insertions(+) >> >> diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi b/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi >> index ce105fe..4493bce 100644 >> --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi >> +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi >> @@ -93,6 +93,18 @@ >> compatible = "mmc-pwrseq-emmc"; >> reset-gpios = <&gpio BOOT_9 GPIO_ACTIVE_LOW>; >> }; >> + >> + usb_vbus: regulator-usb0-vbus { > > nit: I like to use the signal name from the schematics for the node name > (and for regulator-name below). In the schematics, that signal is named > USB_PWR. > > >> + compatible = "regulator-fixed"; >> + >> + regulator-name = "USB0_VBUS"; >> + regulator-min-microvolt = <5000000>; >> + regulator-max-microvolt = <5000000>; >> + >> + gpio = <&gpio GPIODV_24 GPIO_ACTIVE_HIGH>; > > Please add a comment above this line with the schematic signal name: USB_PWR_EN. > For the record... after a chat with Martin on IRC, I just fixed these up myself locally, so... Applied, Kevin -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html