On Fri, Sep 2, 2016 at 12:04 PM, Christoph Fritz <chf.fritz@xxxxxxxxxxxxxx> wrote: > Here on my board I'm using the reset pin as an open-drain with external > pullup, so GPIO_ACTIVE_HIGH is valid. > > As this is an example, I don't care if it says _HIGH or _LOW. Then probably it is better to remove "reset-gpios" from the example. The driver does not parse this dt property and the reset is being done via software command as far as I can see. -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html