Re: [PATCH] iio: sx9500: add final devicetree support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On Fri, 2016-09-02 at 11:53 -0300, Fabio Estevam wrote:
> On Fri, Sep 2, 2016 at 11:49 AM, Christoph Fritz
> <chf.fritz@xxxxxxxxxxxxxx> wrote:
> 
> > +sx9500@28 {
> > +       compatible = "semtech,sx9500";
> > +       reg = <0x28>;
> > +       pinctrl-names = "default";
> > +       pinctrl-0 = <&pinctrl_sx9500>;
> > +       interrupt-parent = <&gpio2>;
> > +       interrupts = <16 IRQ_TYPE_LEVEL_LOW>;
> > +       reset-gpios = <&gpio2 10 GPIO_ACTIVE_HIGH>;
> 
> Datasheet says the reset is active low.

Here on my board I'm using the reset pin as an open-drain with external
pullup, so GPIO_ACTIVE_HIGH is valid.

As this is an example, I don't care if it says _HIGH or _LOW.

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux