On Tue, Aug 30, 2016 at 04:53:01PM +0100, Paul Burton wrote:
> On 26/08/16 18:44, Stephen Boyd wrote:
> > On 08/26, Paul Burton wrote:
> >> diff --git a/Documentation/devicetree/bindings/clock/img,boston-clock.txt b/Documentation/devicetree/bindings/clock/img,boston-clock.txt
> >> new file mode 100644
> >> index 0000000..c01ea60
> >> --- /dev/null
> >> +++ b/Documentation/devicetree/bindings/clock/img,boston-clock.txt
> >> @@ -0,0 +1,27 @@
> >> +Binding for Imagination Technologies MIPS Boston clock sources.
> >> +
> >> +This binding uses the common clock binding[1].
> >> +
> >> +[1] Documentation/devicetree/bindings/clock/clock-bindings.txt
> >> +
> >> +Required properties:
> >> +- compatible : Should be "img,boston-clock".
> >> +- #clock-cells : Should be set to 1.
> >> + Values available for clock consumers can be found in the header file:
> >> + <dt-bindings/clock/boston-clock.h>
> >> +- regmap : Phandle to the Boston platform register system controller.
> >> + This should contain a phandle to the system controller node covering the
> >> + platform registers provided by the Boston board.
> >> +
> >> +Example:
> >> +
> >> + clk_boston: clock {
> >> + compatible = "img,boston-clock";
> >> + #clock-cells = <1>;
> >> + regmap = <&plat_regs>;
> >
> > Isn't syscon more standard than regmap as the property name? Is
> > there a binding for the plat_regs device? Is there any reason the
> > clks can't be populated in that syscon driver?
>
> Hi Stephen,
>
> The plat_regs device doesn't have a custom driver, it simply makes use
> of the generic "syscon" driver which can provide a regmap.
>
> It would be possible to register the clocks from a register for the
> plat_regs device, but I don't think it would make much sense. The
> platform registers in question are essentially just a convenient place
> where various bits of information about the system are exposed,
> including the clock frequencies but also other bits & pieces like
> connectivity of PCIe controllers or I/O coherence units, the RTL
> revision of the CPU or the wrapper RTL that runs on this FPGA-based
> board, a register that allows for resetting the board, etc. It's not a
> single piece of hardware, more a dumping ground for miscellanea. So in
> my opinion using the syscon approach works best here, and drivers for
> well defined pieces of hardware or functionality can reference that
> syscon to retrieve the regmap.
That is all quite common for any SoC. Whether it's 2 nodes or 2 drivers
are independent questions. You can easily have 1 node and 2 drivers. The
decision factor is really how many registers we're dealing with. We
don't want to end up with a node per register or register field. That's
too fine grained.
> As for whether "syscon" is a more standard property name than "regmap",
> both seem to be used based on a grep of
> Documentation/devicetree/bindings/. I believe I picked up use of
> "regmap" from the generic syscon-poweroff & syscon-reboot drivers, which
> both use "regmap" as a property name.
syscon is much more common.
Avoid the phandle altogether and make this a child node.
Rob
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
