Re: [PATCH 1/2] ARM: dts: exynos: Fix mismatched value for SD4 pull up/down configuration on exynos4210

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




Hello Krzysztof,

On 09/01/2016 10:37 AM, Krzysztof Kozlowski wrote:
> The pinctrl pull up/down register on exynos4210 is 2-bit wide for each
> pin and it accepts only values of 0, 1 and 3.  The pins sd4-bus-width8
> were configured with value of 4.  The driver does not validate the value
> so this overflow effectively set a bit 1 in adjacent pins thus
> configuring them to pull down.
> 
> The author's intention was probably to set drive strength of 4x.  All
> other bus-widths pins are configured with pull up and drive strength of
> 4x.  Fix this one with same pattern.
> 
> Fixes: 87711d8c7c70 ("ARM: dts: Add pinctrl node entries for SAMSUNG EXYNOS4210 SoC")
> Signed-off-by: Krzysztof Kozlowski <k.kozlowski@xxxxxxxxxxx>
> ---

Reviewed-by: Javier Martinez Canillas <javier@xxxxxxxxxxxxxxx>

Best regards,
-- 
Javier Martinez Canillas
Open Source Group
Samsung Research America
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux