Hi Milo,
On Fri, Aug 26, 2016 at 05:00:37PM +0900, Milo Kim wrote:
> On 08/26/2016 04:10 PM, Maxime Ripard wrote:
> >>+ uart1_pins_a: uart1@0 {
> >>> + allwinner,pins = "PG6", "PG7";
> >>> + allwinner,function = "uart1";
> >>> + allwinner,drive = <SUN4I_PINCTRL_10_MA>;
> >>> + allwinner,pull = <SUN4I_PINCTRL_NO_PULL>;
> >>> + };
> >>> +
> >Our policy is that we don't introduce new pinctrl nodes that are not
> >used by any board to avoid bloating the DT too much with unused nodes.
> >
> >If you have a board using it, please submit that change as well.
>
> OK, I agree.
>
> However, this pinmux is only useful in case PA5 is assigned for PWM.
> PA5 is commonly used for UART0_RX, so I'd like to add UART1 node into *.dts
> and disable it (status = "disabled"). Does it make sense?
I guess UART1 is either used or not used on that board. In the former
case, it should be enabled, in the latter, left out of the DTS
entirely.
Maxime
--
Maxime Ripard, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com
Attachment:
signature.asc
Description: PGP signature
