The Amlogic reference driver uses the "mc_val" devicetree property to configure the PRG_ETHERNET_ADDR0 register. Unfortunately it uses magic values for this configuration. According to the datasheet the PRG_ETHERNET_ADDR0 register is at address 0xc8834108. However, the reference driver uses 0xc8834540 instead. According to my tests, the value from the reference driver is correct. No changes are required to the board dts files because the only required configuration option is the phy-mode, which had to be configured correctly before as well. Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> --- arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi | 7 ++++--- 1 file changed, 4 insertions(+), 3 deletions(-) diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi b/arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi index 2c200f9..f8cf16e 100644 --- a/arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi @@ -367,13 +367,14 @@ }; ethmac: ethernet@c9410000 { - compatible = "amlogic,meson6-dwmac", "snps,dwmac"; + compatible = "amlogic,meson-gxbb-dwmac", "snps,dwmac"; reg = <0x0 0xc9410000 0x0 0x10000 0x0 0xc8834540 0x0 0x4>; interrupts = <0 8 1>; interrupt-names = "macirq"; - clocks = <&clkc CLKID_ETH>; - clock-names = "stmmaceth"; + clocks = <&clkc CLKID_ETH>, + <&clkc CLKID_FCLK_DIV2>; + clock-names = "stmmaceth", "clkin0"; phy-mode = "rgmii"; status = "disabled"; }; -- 2.9.3 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html