Currently the driver uses two of the three counters the TTC provides to implement a clocksource and a clockevent device. By using the TTC's match feature we can implement both use cases using a single counter only. The old approach is to use timer over-/underflow to generate an interrupt. Using the match register allows to generate an interrupt on arbitrary counter values. This way a dedicated clockevent counter can be avoided. Signed-off-by: Soren Brinkmann <soren.brinkmann@xxxxxxxxxx> --- drivers/clocksource/cadence_ttc_timer.c | 92 +++++++++++---------------------- 1 file changed, 31 insertions(+), 61 deletions(-) diff --git a/drivers/clocksource/cadence_ttc_timer.c b/drivers/clocksource/cadence_ttc_timer.c index b0cd7368b466..b00656371350 100644 --- a/drivers/clocksource/cadence_ttc_timer.c +++ b/drivers/clocksource/cadence_ttc_timer.c @@ -47,6 +47,7 @@ #define TTC_CNT_CNTRL_OFFSET 0x0C /* Counter Control Reg, RW */ #define TTC_COUNT_VAL_OFFSET 0x18 /* Counter Value Reg, RO */ #define TTC_INTR_VAL_OFFSET 0x24 /* Interval Count Reg, RW */ +#define TTC_MATCH1_OFFSET 0x30 /* Match reg, RW */ #define TTC_ISR_OFFSET 0x54 /* Interrupt Status Reg, RO */ #define TTC_IER_OFFSET 0x60 /* Interrupt Enable Reg, RW */ @@ -64,7 +65,10 @@ #define PRESCALE 2048 /* The exponent must match this */ #define CLK_CNTRL_PRESCALE ((PRESCALE_EXPONENT - 1) << 1) #define CLK_CNTRL_PRESCALE_EN 1 -#define CNT_CNTRL_RESET (1 << 4) +#define CNT_CNTRL_RESET BIT(4) +#define CNT_CNTRL_MATCH BIT(3) + +#define TTC_INTERRUPT_MATCH1 BIT(1) #define MAX_F_ERR 50 @@ -100,6 +104,7 @@ struct ttc_timer_clocksource { struct ttc_timer_clockevent { struct ttc_timer ttc; struct clock_event_device ce; + unsigned long interval; }; #define to_ttc_timer_clkevent(x) \ @@ -113,25 +118,20 @@ static void __iomem *ttc_sched_clock_val_reg; * @timer: Pointer to the timer instance * @cycles: Timer interval ticks **/ -static void ttc_set_interval(struct ttc_timer *timer, - unsigned long cycles) +static void ttc_set_interval(struct ttc_timer *timer, unsigned long cycles) { - u32 ctrl_reg; + struct ttc_timer_clockevent *ttcce = container_of(timer, + struct ttc_timer_clockevent, ttc); - /* Disable the counter, set the counter value and re-enable counter */ - ctrl_reg = __raw_readl(timer->base_addr + TTC_CNT_CNTRL_OFFSET); - ctrl_reg |= TTC_CNT_CNTRL_DISABLE_MASK; - __raw_writel(ctrl_reg, timer->base_addr + TTC_CNT_CNTRL_OFFSET); + /* set interval */ + u32 reg = __raw_readl(timer->base_addr + TTC_COUNT_VAL_OFFSET); + reg += cycles; + __raw_writel(reg, timer->base_addr + TTC_MATCH1_OFFSET); - __raw_writel(cycles, timer->base_addr + TTC_INTR_VAL_OFFSET); + /* enable match interrupt */ + __raw_writel(TTC_INTERRUPT_MATCH1, timer->base_addr + TTC_IER_OFFSET); - /* - * Reset the counter (0x10) so that it starts from 0, one-shot - * mode makes this needed for timing to be right. - */ - ctrl_reg |= CNT_CNTRL_RESET; - ctrl_reg &= ~TTC_CNT_CNTRL_DISABLE_MASK; - __raw_writel(ctrl_reg, timer->base_addr + TTC_CNT_CNTRL_OFFSET); + ttcce->interval = cycles; } /** @@ -149,6 +149,8 @@ static irqreturn_t ttc_clock_event_interrupt(int irq, void *dev_id) /* Acknowledge the interrupt and call event handler */ __raw_readl(timer->base_addr + TTC_ISR_OFFSET); + if (ttce->ce.mode == CLOCK_EVT_MODE_PERIODIC) + ttc_set_interval(timer, ttce->interval); ttce->ce.event_handler(&ttce->ce); @@ -202,7 +204,6 @@ static void ttc_set_mode(enum clock_event_mode mode, { struct ttc_timer_clockevent *ttce = to_ttc_timer_clkevent(evt); struct ttc_timer *timer = &ttce->ttc; - u32 ctrl_reg; switch (mode) { case CLOCK_EVT_MODE_PERIODIC: @@ -212,18 +213,9 @@ static void ttc_set_mode(enum clock_event_mode mode, case CLOCK_EVT_MODE_ONESHOT: case CLOCK_EVT_MODE_UNUSED: case CLOCK_EVT_MODE_SHUTDOWN: - ctrl_reg = __raw_readl(timer->base_addr + - TTC_CNT_CNTRL_OFFSET); - ctrl_reg |= TTC_CNT_CNTRL_DISABLE_MASK; - __raw_writel(ctrl_reg, - timer->base_addr + TTC_CNT_CNTRL_OFFSET); + __raw_writel(0, timer->base_addr + TTC_IER_OFFSET); break; case CLOCK_EVT_MODE_RESUME: - ctrl_reg = __raw_readl(timer->base_addr + - TTC_CNT_CNTRL_OFFSET); - ctrl_reg &= ~TTC_CNT_CNTRL_DISABLE_MASK; - __raw_writel(ctrl_reg, - timer->base_addr + TTC_CNT_CNTRL_OFFSET); break; } } @@ -362,17 +354,6 @@ static void __init ttc_setup_clocksource(struct clk *clk, void __iomem *base) ttccs->cs.mask = CLOCKSOURCE_MASK(16); ttccs->cs.flags = CLOCK_SOURCE_IS_CONTINUOUS; - /* - * Setup the clock source counter to be an incrementing counter - * with no interrupt and it rolls over at 0xFFFF. Pre-scale - * it by 32 also. Let it start running now. - */ - __raw_writel(0x0, ttccs->ttc.base_addr + TTC_IER_OFFSET); - __raw_writel(CLK_CNTRL_PRESCALE | CLK_CNTRL_PRESCALE_EN, - ttccs->ttc.base_addr + TTC_CLK_CNTRL_OFFSET); - __raw_writel(CNT_CNTRL_RESET, - ttccs->ttc.base_addr + TTC_CNT_CNTRL_OFFSET); - err = clocksource_register_hz(&ttccs->cs, ttccs->ttc.freq / PRESCALE); if (WARN_ON(err)) { kfree(ttccs); @@ -458,16 +439,6 @@ static void __init ttc_setup_clockevent(struct clk *clk, ttcce->ce.irq = irq; ttcce->ce.cpumask = cpu_possible_mask; - /* - * Setup the clock event timer to be an interval timer which - * is prescaled by 32 using the interval interrupt. Leave it - * disabled for now. - */ - __raw_writel(0x23, ttcce->ttc.base_addr + TTC_CNT_CNTRL_OFFSET); - __raw_writel(CLK_CNTRL_PRESCALE | CLK_CNTRL_PRESCALE_EN, - ttcce->ttc.base_addr + TTC_CLK_CNTRL_OFFSET); - __raw_writel(0x1, ttcce->ttc.base_addr + TTC_IER_OFFSET); - err = request_irq(irq, ttc_clock_event_interrupt, IRQF_DISABLED | IRQF_TIMER, ttcce->ce.name, ttcce); @@ -490,7 +461,7 @@ static void __init ttc_timer_init(struct device_node *timer) { unsigned int irq; void __iomem *timer_baseaddr; - struct clk *clk_cs, *clk_ce; + struct clk *clk; static int initialized; int clksel; @@ -510,7 +481,7 @@ static void __init ttc_timer_init(struct device_node *timer) BUG(); } - irq = irq_of_parse_and_map(timer, 1); + irq = irq_of_parse_and_map(timer, 0); if (irq <= 0) { pr_err("ERROR: invalid interrupt number\n"); BUG(); @@ -518,22 +489,21 @@ static void __init ttc_timer_init(struct device_node *timer) clksel = __raw_readl(timer_baseaddr + TTC_CLK_CNTRL_OFFSET); clksel = !!(clksel & TTC_CLK_CNTRL_CSRC_MASK); - clk_cs = of_clk_get(timer, clksel); - if (IS_ERR(clk_cs)) { + clk = of_clk_get(timer, clksel); + if (IS_ERR(clk)) { pr_err("ERROR: timer input clock not found\n"); BUG(); } - clksel = __raw_readl(timer_baseaddr + 4 + TTC_CLK_CNTRL_OFFSET); - clksel = !!(clksel & TTC_CLK_CNTRL_CSRC_MASK); - clk_ce = of_clk_get(timer, clksel); - if (IS_ERR(clk_ce)) { - pr_err("ERROR: timer input clock not found\n"); - BUG(); - } + __raw_writel(CLK_CNTRL_PRESCALE | CLK_CNTRL_PRESCALE_EN, + timer_baseaddr + TTC_CLK_CNTRL_OFFSET); + + /* start timer in overflow and match mode */ + __raw_writel(CNT_CNTRL_RESET | CNT_CNTRL_MATCH, + timer_baseaddr + TTC_CNT_CNTRL_OFFSET); - ttc_setup_clocksource(clk_cs, timer_baseaddr); - ttc_setup_clockevent(clk_ce, timer_baseaddr + 4, irq); + ttc_setup_clocksource(clk, timer_baseaddr); + ttc_setup_clockevent(clk, timer_baseaddr, irq); pr_info("%s #0 at %p, irq=%d\n", timer->name, timer_baseaddr, irq); } -- 1.8.4.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html