On Thursday, July 14, 2016 5:15:06 PM CEST Andrew Lunn wrote: > On Thu, Jul 14, 2016 at 04:33:26PM +0200, Arnd Bergmann wrote: > > On Thursday, July 14, 2016 4:29:43 PM CEST Philipp Zabel wrote: > > > + > > > + - micrel,fiber-mode: If present the PHY is configured to operate in fiber mode > > > + > > > + Some PHYs, such as the KSZ8041FTL variant, support fiber mode, enabled > > > + by the FXEN boot strapping pin. It can't be determined from the PHY > > > + registers whether the PHY is in fiber mode, so this boolean device tree > > > + property can be used to describe it. > > > + > > > + In fiber mode, auto-negotiation is disabled and the PHY can only work in > > > + 100base-fx (full and half duplex) modes. > > > > > > > Could the generic "phy-mode" property used for this, to avoid the need for > > definingn a custom property? > > Hi Arnd > > phy-mode is about the link between the MAC and the PHY. This property > is about the link between the PHY and its peer PHY. > Ok, got it. Arnd -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
