Hi Po
在 2016/7/5 11:03, Po Liu 写道:
Hi Dongdong,
The patch were intend to fixup the NXP layerscape serial SOC and were tested ok.
I am not clear what platform are you trying to fix.
My platform is an ARM64 platform, PCIe host controller also use Synopsys Designware.
The problem on your board may be as below comments:
-----Original Message-----
From: Dongdong Liu [mailto:liudongdong3@xxxxxxxxxx]
Sent: Monday, July 04, 2016 4:44 PM
To: Po Liu; linux-pci@xxxxxxxxxxxxxxx; linux-arm-
kernel@xxxxxxxxxxxxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx;
devicetree@xxxxxxxxxxxxxxx
Cc: Bjorn Helgaas; Shawn Guo; Marc Zyngier; Rob Herring; Roy Zang;
Mingkai Hu; Stuart Yoder; Yang-Leo Li; Arnd Bergmann; Minghuan Lian;
Murali Karicheri; Linuxarm
Subject: Re: [PATCH v3 2/2] pci/aer: interrupt fixup in the quirk
Hi Po
I found a problem with the similar patch. as the below log.
[ 4.287060] pci 0000:80:00.0: quirk_aer_interrupt dev->irq 416
[ 4.293778] pcieport 0000:80:00.0: pci_device_probe in
[ 4.299605] pcieport 0000:80:00.0: of_irq_parse_pci() failed with
rc=-22
[ 4.307209] pcieport 0000:80:00.0: init_service_irqs dev->irq 0
The fucntions are called as below sequence.
1. quirk_aer_interrupt, get the aer dev->irq 416.
This code quirk_aer_interrupt() should be run at pci_fixup_device(pci_fixup_final) which is in the pci_bus_add_devices()
Yes, you are right.
2. pci_device_probe->of_irq_parse_pci, of_irq_parse_pci() failed, then
dev->irq changed to 0.
pci_device_probe->of_irq_parse_pci which in the pci_scan_child_bus() run before pci_bus_add_devices(). See dw_pcie_host_init().
Apparently , your quirk_aer_interrupt() is running before the dev->irq assignment in the of_irq_parse_pci().
So make sure your configure the quirk_aer_interrupt() run in the FINAL stage in the quirk.c OR check your host driver which you are using.
Yes , It is FINAL stage in the quirk. I use DECLARE_PCI_FIXUP_FINAL.
I find it is the below patch affect this. (https://patchwork.kernel.org/patch/9170333/),
but the patch will be applied to linux 4.8. So the problem will also be existed.
ARM64: PCI: ACPI support for legacy IRQs parsing and consolidation with DT code
diff --git a/arch/arm64/kernel/pci.c b/arch/arm64/kernel/pci.c
index d5d3d26..b3b8a2c 100644
--- a/arch/arm64/kernel/pci.c
+++ b/arch/arm64/kernel/pci.c
@@ -51,11 +51,16 @@ int pcibios_enable_device(struct pci_dev *dev, int mask)
}
/*
- * Try to assign the IRQ number from DT when adding a new device
+ * Try to assign the IRQ number when probing a new device
*/
-int pcibios_add_device(struct pci_dev *dev)
+int pcibios_alloc_irq(struct pci_dev *dev)
{
- dev->irq = of_irq_parse_and_map_pci(dev, 0, 0);
+ if (acpi_disabled)
+ dev->irq = of_irq_parse_and_map_pci(dev, 0, 0);
+#ifdef CONFIG_ACPI
+ else
+ return acpi_pci_irq_enable(dev);
+#endif
return 0;
}
Thanks
Dongdong
So this patch could not work with aer.
Thanks
Dongdong
在 2016/6/14 16:24, Po Liu 写道:
> On some platforms, root port doesn't support MSI/MSI-X/INTx in RC mode.
> When chip support the aer interrupt with none MSI/MSI-X/INTx mode,
> maybe there is interrupt line for aer pme etc. Search the interrupt
> number in the fdt file. Then fixup the dev->irq with it.
>
> Signed-off-by: Po Liu <po.liu@xxxxxxx>
> ---
> changes for V3:
> - Move to quirk;
> - Only correct the irq in RC mode;
>
> drivers/pci/quirks.c | 29 +++++++++++++++++++++++++++++
> 1 file changed, 29 insertions(+)
>
> diff --git a/drivers/pci/quirks.c b/drivers/pci/quirks.c index
> ee72ebe..8b39cce 100644
> --- a/drivers/pci/quirks.c
> +++ b/drivers/pci/quirks.c
> @@ -25,6 +25,7 @@
> #include <linux/sched.h>
> #include <linux/ktime.h>
> #include <linux/mm.h>
> +#include <linux/of_irq.h>
> #include <asm/dma.h> /* isa_dma_bridge_buggy */
> #include "pci.h"
>
> @@ -4419,3 +4420,31 @@ static void quirk_intel_qat_vf_cap(struct
pci_dev *pdev)
> }
> }
> DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_INTEL, 0x443,
> quirk_intel_qat_vf_cap);
> +
> +/* If root port doesn't support MSI/MSI-X/INTx in RC mode,
> + * but use standalone irq. Read the device tree for the aer
> + * interrupt number.
> + */
> +static void quirk_aer_interrupt(struct pci_dev *dev) {
> + int ret;
> + u8 header_type;
> + struct device_node *np = NULL;
> +
> + /* Only for the RC mode device */
> + pci_read_config_byte(dev, PCI_HEADER_TYPE, &header_type);
> + if ((header_type & 0x7F) != PCI_HEADER_TYPE_BRIDGE)
> + return;
> +
> + if (dev->bus->dev.of_node)
> + np = dev->bus->dev.of_node;
> +
> + if (IS_ENABLED(CONFIG_OF_IRQ) && np) {
> + ret = of_irq_get_byname(np, "aer");
> + if (ret > 0) {
> + dev->no_msi = 1;
> + dev->irq = ret;
> + }
> + }
> +}
> +DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_FREESCALE, PCI_ANY_ID,
> +quirk_aer_interrupt);
>
�{.n�+�������+%��lzwm��b�맲��r��zX��\�)���w* jg��� �����ݢj/���z�ޖ��2�ޙ���&�)ߡ�a���� �G���h��j:+v���w�٥
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
