Hi Julian,
thank you for the review. You're right. I added the pinctrl client
nodes. Also the patches were split incorrectly, so I fixed that too.
regards,
Ondrej
On 24.6.2016 04:51, Julian Calaby wrote:
> Hi Ondrej,
>
> On Fri, Jun 24, 2016 at 5:21 AM, <megous@xxxxxxxxxx> wrote:
>> From: Ondrej Jirman <megous@xxxxxxxxxx>
>>
>> Xulong Orange Pi One uses GPIO based regulator that
>> switches between two voltages: 1.1V and 1.3V. The
>> regulator is controlled from the PL6 pin.
>>
>> Signed-off-by: Ondrej Jirman <megous@xxxxxxxxxx>
>> ---
>> arch/arm/boot/dts/sun8i-h3-orangepi-one.dts | 26 ++++++++++++++++++++++++++
>> 1 file changed, 26 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts b/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts
>> index 0adf932..ce4ba91 100644
>> --- a/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts
>> +++ b/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts
>> @@ -88,6 +88,25 @@
>> gpios = <&r_pio 0 3 GPIO_ACTIVE_LOW>;
>> };
>> };
>> +
>> + vdd_soc: gpio-regulator {
>> + compatible = "regulator-gpio";
>> +
>> + regulator-name = "soc-vdd-supply";
>> + regulator-min-microvolt = <1100000>;
>> + regulator-max-microvolt = <1300000>;
>> + regulator-boot-on;
>> + regulator-type = "voltage";
>> +
>> + gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>;
>> + states = <1100000 0x0
>> + 1300000 0x1>;
>> +
>> + startup-delay-us = <100000>;
>> + enable-active-high;
>
> Don't you need to reference the new pinctl node in this one?
>
> Thanks,
>
Attachment:
signature.asc
Description: OpenPGP digital signature
