Shawn,
On Wed, Jun 8, 2016 at 1:05 AM, Shawn Lin <shawn.lin@xxxxxxxxxxxxxx> wrote:
> +pcie0: pcie@f8000000 {
> + compatible = "rockchip,rk3399-pcie";
> + #address-cells = <3>;
> + #size-cells = <2>;
> + clocks = <&cru ACLK_PCIE>, <&cru ACLK_PERF_PCIE>,
> + <&cru PCLK_PCIE>;
> + clock-names = "aclk", "aclk-perf",
> + "hclk";
Code also requires a "pm" clock.
> + bus-range = <0x0 0x1>;
> + interrupts = <GIC_SPI 49 IRQ_TYPE_LEVEL_HIGH>, <GIC_SPI 50 IRQ_TYPE_LEVEL_HIGH>,
> + <GIC_SPI 51 IRQ_TYPE_LEVEL_HIGH>;
> + interrupt-names: "sys", "legacy", "client";
Shouldn't be ":", should be "=".
> + assigned-clocks = <&cru SCLK_PCIEPHY_REF>;
> + assigned-clock-parents = <&cru SCLK_PCIEPHY_REF100M>;
> + assigned-clock-rates = <100000000>;
> + ep-gpios = <&gpio3 13 GPIO_ACTIVE_HIGH>;
> + ranges = < 0x82000000 0 0xfa000000 0x0 0xfa000000 0 0x600000
> + 0x81000000 0 0xfa600000 0x0 0xfa600000 0 0x100000 >;
nit: I don't thin it's common to have spaces before/after the ">" and "<".
nit: Be consistent about 0 vs. 0x0 in ranges.
> + num-lanes = <4>;
> + reg = < 0x0 0xf8000000 0x0 0x2000000 >, < 0x0 0xfd000000 0x0 0x1000000 >;
> + reg-name = "axi-base", "apb-base";
Should be "reg-names" (with an "s")
> + resets = <&cru SRST_PCIEPHY>, <&cru SRST_PCIE_CORE>, <&cru SRST_PCIE_MGMT>,
> + <&cru SRST_PCIE_MGMT_STICKY>, <&cru SRST_PCIE_PIPE>;
> + reset-names = "core", "mgmt", "mgmt-sticky", "pipe";
You have 5 resets but 4 reset names. That doesn't seem right. Code
shows you only getting 4, so presumably you need to remove the
SRST_PCIEPHY one.
-Doug
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
