Re: [PATCH 7/7] pinctrl: tegra: Add driver to configure voltage and power state of io pads

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On Friday 15 April 2016 04:45 PM, Linus Walleij wrote:
On Fri, Apr 15, 2016 at 11:55 AM, Laxman Dewangan <ldewangan@xxxxxxxxxx> wrote:
On Friday 15 April 2016 02:55 PM, Linus Walleij wrote:
If the pin could actually set a voltage level it would have a regulator.
I don't believe that. I think it is selecting one of two rails which
could theoretically hold two totally different voltages.

And that is what power-source is about.
The IO rails connected to PMIC rail and connection does not get change.
We change the voltage of PMIC rails via regulator calls. And then configure
pads for the new voltage.
Aha I get it! So you adjust something in the I/O-cell so that it is adapted
for the new voltage.

OK that seems to be something new. I suspect
power-voltage-select = <n>; where N i in uV would solve this?
(We should use uV since regulators use this.)

Thanks for new property. I will make the unit and type same as the regulator framework.




But to be sure we would like to know what is actually happening,
electronically speaking, when you set this up. Do you have any
idea?



From electronic point of view, the value of VIL, VIH, VOL, VOH (Input/output voltage level for low and high state) are different when talking for 0 t 1.8V and 0 to 3.3V.




--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux