On 10/03/2016 at 16:37:40 +0100, Nicolas Ferre wrote :
> +ATMEL AT91 Alternative Shutdown Controller
Can't that be sama5d2 instead of alternative?
> +M: Nicolas Ferre <nicolas.ferre@xxxxxxxxx>
> +S: Supported
> +F: drivers/power/reset/at91-shdwc.c
I would also use that in the filename. Because once there is a third
shdwc, I'm not sure how you will be able to name it.
> +config POWER_RESET_AT91_SHDWC
I would also include that in the config name.
> + tristate "Atmel AT91 shutdown controller driver"
> + depends on ARCH_AT91 || COMPILE_TEST
> + default SOC_SAMA5
> + help
> + This driver supports the alternate shutdown controller for some Atmel
> + SAMA5 SoCs. It is present for example on SAMA5D2 SoC.
> +
> +#include <linux/clk.h>
> +#include <linux/io.h>
> +#include <linux/module.h>
> +#include <linux/of.h>
> +#include <linux/platform_device.h>
> +#include <linux/printk.h>
> +
> +#define SLOW_CLOCK_FREQ 32768
> +
> +#define AT91_SHDW_CR 0x00 /* Shut Down Control Register */
> +#define AT91_SHDW_SHDW BIT(0) /* Shut Down command */
> +#define AT91_SHDW_KEY (0xa5UL << 24) /* KEY Password */
> +
> +#define AT91_SHDW_MR 0x04 /* Shut Down Mode Register */
> +#define AT91_SHDW_WKUPDBC_SHIFT 24
> +#define AT91_SHDW_WKUPDBC_MASK GENMASK(31, 16)
> +#define AT91_SHDW_WKUPDBC(x) (((x) << AT91_SHDW_WKUPDBC_SHIFT) \
> + & AT91_SHDW_WKUPDBC_MASK)
> +
> +#define AT91_SHDW_SR 0x08 /* Shut Down Status Register */
> +#define AT91_SHDW_WKUPIS_SHIFT 16
> +#define AT91_SHDW_WKUPIS_MASK GENMASK(31, 16)
> +#define AT91_SHDW_WKUPIS(x) ((1 << (x)) << AT91_SHDW_WKUPIS_SHIFT \
> + & AT91_SHDW_WKUPIS_MASK)
> +
> +#define AT91_SHDW_WUIR 0x0c /* Shutdown Wake-up Inputs Register */
> +#define AT91_SHDW_WKUPEN_MASK GENMASK(15, 0)
> +#define AT91_SHDW_WKUPEN(x) ((1 << (x)) & AT91_SHDW_WKUPEN_MASK)
> +#define AT91_SHDW_WKUPT_SHIFT 16
> +#define AT91_SHDW_WKUPT_MASK GENMASK(31, 16)
> +#define AT91_SHDW_WKUPT(x) ((1 << (x)) << AT91_SHDW_WKUPT_SHIFT \
> + & AT91_SHDW_WKUPT_MASK)
> +
> +#define SHDW_WK_PIN(reg, cfg) ((reg) & AT91_SHDW_WKUPIS((cfg)->wkup_pin_input))
> +#define SHDW_RTCWK(reg, cfg) (((reg) >> ((cfg)->sr_rtcwk_shift)) & 0x1)
> +#define SHDW_RTCWKEN(cfg) (1 << ((cfg)->mr_rtcwk_shift))
> +
> +#define DBC_PERIOD_US(x) DIV_ROUND_UP_ULL((1000000 * (x)), \
> + SLOW_CLOCK_FREQ)
> +
> +struct shdwc_config {
> + u8 wkup_pin_input;
> + u8 mr_rtcwk_shift;
> + u8 sr_rtcwk_shift;
> +};
> +
> +struct shdwc {
> + struct shdwc_config *cfg;
> + void __iomem *at91_shdwc_base;
> +};
> +
> +/*
> + * Hold configuration here, cannot be more than one instance of the driver
> + * since pm_power_off itself is global.
> + */
> +static struct shdwc *at91_shdwc;
> +static struct clk *sclk;
> +
> +static const unsigned long long sdwc_dbc_period[] = {
> + 0, 3, 32, 512, 4096, 32768,
> +};
> +
> +static void __init at91_wakeup_status(struct platform_device *pdev)
> +{
> + struct shdwc *shdw = platform_get_drvdata(pdev);
> + u32 reg;
> + char *reason = "unknown";
> +
> + reg = readl(shdw->at91_shdwc_base + AT91_SHDW_SR);
> +
> + dev_dbg(&pdev->dev, "%s: status = %#x\n", __func__, reg);
> +
> + /* Simple power-on, just bail out */
> + if (!reg)
> + return;
> +
> + if (SHDW_WK_PIN(reg, shdw->cfg))
> + reason = "WKUP pin";
> + else if (SHDW_RTCWK(reg, shdw->cfg))
> + reason = "RTC";
> +
> + pr_info("AT91: Wake-Up source: %s\n", reason);
> +}
> +
> +static void at91_poweroff(void)
> +{
> + writel(AT91_SHDW_KEY | AT91_SHDW_SHDW,
> + at91_shdwc->at91_shdwc_base + AT91_SHDW_CR);
This is still not properly aligned :)
> +}
> +
> +static u32 at91_shdwc_debouncer_value(struct platform_device *pdev,
> + u32 in_period_us)
> +{
> + int i;
> + int max_idx = ARRAY_SIZE(sdwc_dbc_period) - 1;
> + unsigned long long period_us;
> + unsigned long long max_period_us = DBC_PERIOD_US(sdwc_dbc_period[max_idx]);
> +
> + if (in_period_us > max_period_us) {
> + dev_warn(&pdev->dev,
> + "debouncer period %u too big, reduced to %llu us\n",
> + in_period_us, max_period_us);
> + return max_idx;
> + }
> +
> + for (i = max_idx - 1; i > 0; i--) {
> + period_us = DBC_PERIOD_US(sdwc_dbc_period[i]);
> + dev_dbg(&pdev->dev, "%s: ref[%d] = %llu\n",
> + __func__, i, period_us);
Alignment is not correct.
> + if (in_period_us > period_us)
> + break;
> + }
> +
> + return i + 1;
> +}
> +
> +static u32 at91_shdwc_get_wakeup_input(struct platform_device *pdev,
> + struct device_node *np)
> +{
> + struct device_node *cnp;
> + u32 wk_input_mask;
> + u32 wuir = 0;
> + u32 wk_input;
> +
> + for_each_child_of_node(np, cnp) {
> + if (of_property_read_u32(cnp, "reg", &wk_input)) {
> + dev_warn(&pdev->dev, "reg property is missing for %s\n",
> + cnp->full_name);
> + continue;
> + }
> +
> + wk_input_mask = 1 << wk_input;
> + if (!(wk_input_mask & AT91_SHDW_WKUPEN_MASK)) {
> + dev_warn(&pdev->dev,
> + "wake-up input %d out of bounds ignore\n",
> + wk_input);
> + continue;
> + }
> + wuir |= wk_input_mask;
> +
> + if (of_property_read_bool(cnp, "atmel,wakeup-active-high"))
> + wuir |= AT91_SHDW_WKUPT(wk_input);
> +
> + dev_dbg(&pdev->dev, "%s: (child %d) wuir = %#x\n",
> + __func__, wk_input, wuir);
Alignment is not correct
--
Alexandre Belloni, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
