Add mdio node and an appropriate PHY configuration to enable use of the PHY interrupt for link status changes. Signed-off-by: Lothar Waßmann <LW@xxxxxxxxxxxxxxxxxxx> --- arch/arm/boot/dts/imx6qdl-tx6.dtsi | 14 ++++++++++++++ 1 file changed, 14 insertions(+) diff --git a/arch/arm/boot/dts/imx6qdl-tx6.dtsi b/arch/arm/boot/dts/imx6qdl-tx6.dtsi index dc813c2..a0d59ab 100644 --- a/arch/arm/boot/dts/imx6qdl-tx6.dtsi +++ b/arch/arm/boot/dts/imx6qdl-tx6.dtsi @@ -249,8 +249,22 @@ clock-names = "ipg", "ahb", "ptp", "enet_out"; phy-mode = "rmii"; phy-reset-gpios = <&gpio7 6 GPIO_ACTIVE_HIGH>; + phy-handle = <&etnphy>; phy-supply = <®_3v3_etn>; status = "okay"; + + mdio { + #address-cells = <1>; + #size-cells = <0>; + + etnphy: ethernet-phy@0 { + compatible = "ethernet-phy-ieee802.3-c22"; + reg = <0>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_enet_mdio>; + interrupts-extended = <&gpio7 1 IRQ_TYPE_EDGE_FALLING>; + }; + }; }; &gpmi { -- 2.1.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html