Hi,
On 3/4/2016 9:17 PM, Arnd Bergmann wrote:
> On Friday 04 March 2016 17:22:19 Joao Pinto wrote:
>> This patch adds a glue pci driver for the Synopsys G210 Test Chip.
>>
>> Signed-off-by: Joao Pinto <jpinto@xxxxxxxxxxxx>
>
> Mostly ok, just a few suggestions:
>
>> +
>> +/* Test Chip type expected values */
>> +#define TC_G210_20BIT 20
>> +#define TC_G210_40BIT 40
>> +#define TC_G210_DEFAULTBIT 40
>> +
>> +static int tc_type = TC_G210_DEFAULTBIT;
>> +module_param(tc_type, int, 0);
>> +MODULE_PARM_DESC(tc_type, "Test Chip Type (20 = 20-bit, 40 = 40-bit)");
>>
>
> What is the effect of setting the wrong one here? I was thinking
> it would be best to have the default be 'invalid' and then return
> an error from the probe() function when you neither value is
> set.
You're right. Maybe an TC_G210_20BIT_INV by default and also check if the
inserted value is TC_G210_20BIT or TC_G210_40BIT. if not, then abort the probe.
>
>> +
>> + /* Check Test Chip type and set the specific setup routine */
>> + if (tc_type == TC_G210_20BIT) {
>> + tc_dwc_g210_pci_hba_vops.custom_phy_initialization =
>> + tc_dwc_g210_config_20_bit;
>> + } else if (tc_type == TC_G210_40BIT) {
>> + tc_dwc_g210_pci_hba_vops.custom_phy_initialization =
>> + tc_dwc_g210_config_40_bit;
>> + }
>
> As for the platform driver, I would define two separate structures here,
> and then mark the operations as 'const'.
>
>> +static const struct pci_device_id tc_dwc_g210_pci_tbl[] = {
>> + { PCI_VENDOR_ID_SYNOPSYS, 0xB101, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0 },
>> + { PCI_VENDOR_ID_SYNOPSYS, 0xB102, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0 },
>> + { } /* terminate list */
>> +};
>
> Is there any difference between these two IDs?
The Synopsys can be identified by one of these 2 IDs. There is no particular reason.
>
> Arnd
>
Joao
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
