Hi Peter,
On 03.03.2016 11:01, Peter Chen wrote:
> From: Peter Chen <peter.chen@xxxxxxxxxxxxx>
>
> The current dts describes USB HUB's property at USB controller's
> entry, it is improper. The USB HUB should be the child node
> under USB controller.
>
> Signed-off-by: Peter Chen <peter.chen@xxxxxxxxxxxxx>
Thanks for patches!
VID:PID for hub on UDOO board is 0424:2514.
I've tested these patches on this board and was able to make USB work
again with following DT changes:
diff --git a/arch/arm/boot/dts/imx6qdl-udoo.dtsi b/arch/arm/boot/dts/imx6qdl-udoo.dtsi
index d3e54e4..4956de7 100644
--- a/arch/arm/boot/dts/imx6qdl-udoo.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-udoo.dtsi
@@ -9,6 +9,8 @@
*
*/
+#include <dt-bindings/gpio/gpio.h>
+
/ {
chosen {
stdout-path = &uart2;
@@ -18,21 +27,11 @@
reg = <0x10000000 0x40000000>;
};
- regulators {
- compatible = "simple-bus";
- #address-cells = <1>;
- #size-cells = <0>;
-
- reg_usb_h1_vbus: regulator@0 {
- compatible = "regulator-fixed";
- reg = <0>;
- regulator-name = "usb_h1_vbus";
- regulator-min-microvolt = <5000000>;
- regulator-max-microvolt = <5000000>;
- enable-active-high;
- startup-delay-us = <2>; /* USB2415 requires a POR of 1 us minimum */
- gpio = <&gpio7 12 0>;
- };
+ usb2415_pwrseq: usb2415_pwrseq {
+ compatible = "usb-pwrseq";
+ clocks = <&clks IMX6QDL_CLK_CKO>;
+ reset-gpios = <&gpio7 12 GPIO_ACTIVE_LOW>;
+ reset-duration-us = <3000>;
};
sound {
@@ -163,9 +218,16 @@
&usbh1 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_usbh>;
- vbus-supply = <®_usb_h1_vbus>;
- clocks = <&clks 201>;
status = "okay";
+
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ hub: usb2415@01 {
+ compatible = "usb424,2514";
+ reg = <1>;
+ usb-pwrseq = <&usb2415_pwrseq>;
+ };
};
&usdhc3 {
Maciej
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
