On 02/26/2016 11:19 AM, Eric Anholt wrote:
The BCM2835-ARM-Peripherals.pdf documentation specifies what the
function selects do for the pins, and there are a bunch of obvious
groupings to be made. With these created, we'll be able to replace
bcm2835-rpi.dtsi's main "set all of these pins to alt0" with
references to specific groups we want enabled.
diff --git a/arch/arm/boot/dts/bcm283x.dtsi b/arch/arm/boot/dts/bcm283x.dtsi
+ spi0_gpio7: spi0_gpio7 {
+ brcm,pins = <7 8 9 10 11>;
+ brcm,function = <BCM2835_FSEL_ALT0>;
+ };
This is too many pins.
- It includes both MOSI and MISO, although a particular use-case may
only use 1 of those.
- It includes both chip-select signals, whereas a particular use-case
may use 0, 1, or 2 of those. This is especially true since IIRC the
mainline bcm283x SPI driver wants to only use GPIOs for chip-selects,
not SPI-controller-generated chip-select signals, to avoid some issues
with the HW generation of these signals.
I believe a similar comment applies to other SPI nodes too.
+ pcm_gpio18: pcm_gpio18 {
+ brcm,pins = <18 19 20 21>;
+ brcm,function = <BCM2835_FSEL_ALT0>;
+ };
Here too, I wonder if some people might want only one of DIN/DOUT and
not both?
+ uart1_gpio36: uart1_gpio36 {
+ brcm,pins = <36 37 38 39>;
+ brcm,function = <BCM2835_FSEL_ALT2>;
+ };
Similarly, I think for UARTS, TX/RX and RTS/CTS should always be in
different nodes so people can choose 2- or 4-wire mode. Most of the UART
nodes are already split like this, but this one isn't.
+ emmc_gpio22: emmc_gpio22 {
+ brcm,pins = <22 23 24 25 26 27>;
+ brcm,function = <BCM2835_FSEL_ALT3>;
+ };
1-wire (1 data wire, plus CLK/CMD) eMMC is possible in theory, although
I don't know whether it makes sense to support this?
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
