to indicate flow control support. Signed-off-by: Oleksij Rempel <linux@xxxxxxxxxxxxxxxx> --- drivers/spi/spi-davinci.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) diff --git a/drivers/spi/spi-davinci.c b/drivers/spi/spi-davinci.c index fddb7a3..8728df9 100644 --- a/drivers/spi/spi-davinci.c +++ b/drivers/spi/spi-davinci.c @@ -351,8 +351,8 @@ static int davinci_spi_setup_transfer(struct spi_device *spi, * * Version 2 hardware supports an optional handshaking signal, * so it can support two more modes: - * - 5 pin SPI variant is standard SPI plus SPI_READY - * - 4 pin with enable is (SPI_READY | SPI_NO_CS) + * - 5 pin SPI variant is standard SPI plus SPI_FC_READY + * - 4 pin with enable is (SPI_FC_READY | SPI_NO_CS) */ if (dspi->version == SPI_VERSION_2) { @@ -374,7 +374,7 @@ static int davinci_spi_setup_transfer(struct spi_device *spi, & SPIDELAY_T2CDELAY_MASK; } - if (spi->mode & SPI_READY) { + if (spi->mode & SPI_FC_READY) { spifmt |= SPIFMT_WAITENA_MASK; delay |= (spicfg->t2edelay << SPIDELAY_T2EDELAY_SHIFT) & SPIDELAY_T2EDELAY_MASK; @@ -452,7 +452,7 @@ static int davinci_spi_setup(struct spi_device *spi) set_io_bits(dspi->base + SPIPC0, 1 << spi->chip_select); } - if (spi->mode & SPI_READY) + if (spi->mode & SPI_FC_READY) set_io_bits(dspi->base + SPIPC0, SPIPC0_SPIENA_MASK); if (spi->mode & SPI_LOOP) @@ -1021,7 +1021,7 @@ static int davinci_spi_probe(struct platform_device *pdev) dspi->bitbang.flags = SPI_NO_CS | SPI_LSB_FIRST | SPI_LOOP; if (dspi->version == SPI_VERSION_2) - dspi->bitbang.flags |= SPI_READY; + dspi->bitbang.flags |= SPI_FC_HW_ONLY | SPI_FC_READY | SPI_FC_PAUSE; if (pdev->dev.of_node) { int i; -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html