On 2/6/2016 3:42 AM, Paul Kocialkowski wrote:
Some devices don't hook the DVS pin to a GPIO but to ground or VCC.
In those cases, it is not a problem to have no DVS GPIO provided, as the current
code will already switch to software-only DVS selection:
When the DVS GPIO is invalid, lp872x_init_dvs jumps to the set_default_dvs_mode
label, which instructs the chip not to use the DVS pin at all and do it all in
software instead (by clearing the LP8720_EXT_DVS_M bit in the
LP872X_GENERAL_CFG register).
That is reflected later in the code, when setting the bucks (the DVS pin only
applies to the bucks) by checking for the LP8720_EXT_DVS_M bit on the
LP872X_GENERAL_CFG register (in lp872x_select_buck_vout_addr) to decide whether
to use software or hardware DVS selection.
Thus, there is no need to print a warning when the DVS GPIO is invalid.
Signed-off-by: Paul Kocialkowski <contact@xxxxxxxx>
Acked-by: Milo Kim <milo.kim@xxxxxx>
---
drivers/regulator/lp872x.c | 4 +---
1 file changed, 1 insertion(+), 3 deletions(-)
diff --git a/drivers/regulator/lp872x.c b/drivers/regulator/lp872x.c
index 19d7584..21c49d8 100644
--- a/drivers/regulator/lp872x.c
+++ b/drivers/regulator/lp872x.c
@@ -738,10 +738,8 @@ static int lp872x_init_dvs(struct lp872x *lp)
goto set_default_dvs_mode;
gpio = dvs->gpio;
- if (!gpio_is_valid(gpio)) {
- dev_warn(lp->dev, "invalid gpio: %d\n", gpio);
+ if (!gpio_is_valid(gpio))
goto set_default_dvs_mode;
- }
pinstate = dvs->init_state;
ret = devm_gpio_request_one(lp->dev, gpio, pinstate, "LP872X DVS");
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
