Re: [PATCH 0/2] CREG clk driver for NXP LPC18xx family

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




Hi Stephen,

On 8 February 2016 at 23:26, Stephen Boyd <sboyd@xxxxxxxxxxxxxx> wrote:
> On 07/11, Joachim Eastwood wrote:
>> This patch set adds a clk driver for the low power clocks found in
>> the CREG block on lpc18xx. CREG is a collection of miscellaneous
>> configuration registers that can be accessed through a syscon
>> regmap interface. The clk driver makes it possible to setup and
>> enabled these two clocks.
>>
>> This need to support peripherals like the internal RTC on the
>> lpc18xx platform.
>>
>
> I know this is many months old, but is this driver still
> required? I can apply it to clk-next if so.

It is still needed for the internal RTC (rtc-lpc24xx) on lpc18xx. The
RTC uses a 1 kHz clock that is controlled in CREG (misc system regs).

Note; if you apply it you will most likely get a very trivial conflict
in drivers/clk/nxp/Makefile because clk-lpc32xx.c has been added since
these patches was sent.


regards,
Joachim Eastwood
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux