Re: [PATCH 1/2] extcon: extcon-dra7xx: Add extcon driver for USB ID detection

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 08/20/2013 12:55 AM, George Cherian wrote:
> Hi Stephen,
> 
> Thanks for your review.
> 
> On 8/20/2013 1:01 AM, Stephen Warren wrote:
> 
>> On 08/16/2013 04:13 AM, George Cherian wrote:
>>> Adding extcon driver for USB ID detection to dynamically
>>> configure USB Host/Peripheral mode.
>>> diff --git
>>> a/Documentation/devicetree/bindings/extcon/extcon-dra7xx.txt
>>> b/Documentation/devicetree/bindings/extcon/extcon-dra7xx.txt
>>> +EXTCON FOR DRA7xx
>>> +
>>> +Required Properties:
>> Please at lest explain what a DRA7xxx is, and the purpose of the HW
>> module this binding describes.
> 
> DRA7xx is the SoC name and the USB VID  detection is implemented via gpio's
> Basically it does only ID detection via GPIO and there is no VBUS
> detection in h/w.

If there's no SoC-specific HW, then the binding has nothing to do with
the SoC; it's entirely generic.

I think instead, you need to define a generic "gpio-usb-vid" binding
instead.

Otherwise, ever SoC that doesn't have explicit USB VID detection HW is
going to re-invent the exact same binding, with pointless differences,
rather than using a single generic binding.

>>> + - compatible : Should be "ti,dra7xx-usb"
>>
>> If this is a USB VID detector rather than a full USB host controller,
>> then "usb" in the binding is a bit over-reaching. Perhaps "-usb-vid" or
>> "-usb-vid-detector" would be more accurate.
> 
> This will be renamed to dra7xx-extcon.

So no, that rename doesn't sound correct.

>>> + - gpios : phandle to ID pin and interrupt gpio.
>>
>> Why does the interrupt line need to be included in a list of GPIOs?
> 
> ID pins are connected to pcf8575, and the pcf8575's interrupt line is
> inturn connected to
> gpio bank6 pin 11, we use this gpio interrupt to detect the ID pin change.

In that case, the PCF8575 node needs to be a GPIO controller and an IRQ
controller, as does the driver for the PCF8575. This binding should have
a single entry in the gpios property, and the driver can call
gpio_to_irq() on that so it knows which IRQ to request.
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux