On Tue, Aug 13, 2013 at 10:09:16AM +0100, Oleksandr Kravchenko wrote: > This patch adds IIO driver for Bosch BMA180 triaxial > acceleration sensor. > http://omapworld.com/BMA180_111_1002839.pdf > > Signed-off-by: Oleksandr Kravchenko <o.v.kravchenko@xxxxxxxxxxxxxxx> > --- > .../devicetree/bindings/iio/accel/bma180.txt | 35 ++ > drivers/iio/accel/Kconfig | 12 + > drivers/iio/accel/Makefile | 2 + > drivers/iio/accel/bma180.c | 635 ++++++++++++++++++++ > 4 files changed, 684 insertions(+) > create mode 100644 Documentation/devicetree/bindings/iio/accel/bma180.txt > create mode 100644 drivers/iio/accel/bma180.c > > diff --git a/Documentation/devicetree/bindings/iio/accel/bma180.txt b/Documentation/devicetree/bindings/iio/accel/bma180.txt > new file mode 100644 > index 0000000..e08780b > --- /dev/null > +++ b/Documentation/devicetree/bindings/iio/accel/bma180.txt > @@ -0,0 +1,35 @@ > +* Bosch BMA180 triaxial acceleration sensor > + > +http://omapworld.com/BMA180_111_1002839.pdf > + > +Required properties: > + > + - compatible : should be "bosch,bma180" > + - reg : the I2C address of the sensor > + > +Optional properties: > + > + - interrupt-parent : should be the phandle for the interrupt controller > + > + - interrupts : interrupt mapping for GPIO IRQ, it should by configured with > + flags IRQ_TYPE_LEVEL_HIGH | IRQ_TYPE_EDGE_RISING > + > + - bosch,resolution : ADC resolution. Must be 130, 190, 250, 380, 500, > + 990 or 1980 mcg/LSB only > + > + - bosch,bandwidth : select bandwidth frequency. Must be 10, 20, 40, 75, > + 150 or 300 Hz only > + > + - bosch,mode : 0 - select low noise mode, 1 - select low power mode
