I could not wait and started working on it right away. An issue was opened to track progress[0] and not spam the mailing list. To be continued. [0] https://tracker.ceph.com/issues/49896 On 18/03/2021 19:00, Loïc Dachary wrote: > Ok then: I'll start working on it tomorrow and ping you when the data is ready. It may take a few weeks because of other obligations but it will happen :-) > > On 18/03/2021 18:42, jmario@xxxxxxxxxx wrote: >> Hi Loïc, >>> If I'm not mistaken, the commands (let say they are in a ceph-c2c.sh script) >>> should be run like this: >>> >>> * Run the software (be it mempool simulation or Ceph under load), let it warm up >>> * Run ceph-c2c.sh (it won't take more than a minute or so to complete) >>> * Collect the data and save them >>> * Kill the software >>> >>> Is that correct? >> That sounds great. >> Thank you. >> Joe >> _______________________________________________ >> Dev mailing list -- dev@xxxxxxx >> To unsubscribe send an email to dev-leave@xxxxxxx -- Loïc Dachary, Artisan Logiciel Libre _______________________________________________ Dev mailing list -- dev@xxxxxxx To unsubscribe send an email to dev-leave@xxxxxxx
