On Fri, 11 Dec 2009 09:58:38 +0000, Christine Caulfield wrote > On 11/12/09 09:48, Kaloyan Kovachev wrote: > > On Thu, 10 Dec 2009 16:12:33 +0000, Christine Caulfield wrote > >> On 10/12/09 15:27, Kaloyan Kovachev wrote: > >>> Hello, > >>> after upgrading to 3.0.6 i get: > >>> > >>> Starting cman... Relax-NG validity error : Extra element cman in interleave > >>> > >>> but cluster.conf should be correct and was working so far without problems. > >>> The coresponding section in<cluster> is: > >>> > >>> <cman expected_votes="7"> > >>> <multicast addr="239.192.11.81" keyfile="/etc/cluster/cman_authkey"/> > >>> </cman> > >>> > >>> how should i change it to pass the validity check? > >> > >> Remove the keyfile="" attribute. cman ignores it anyway :-) > >> > > > > I am sure it was working with RHCM v2, so it seems i will need to rewrite the > > config for V3, as i get another error now about specifying multicast interface > > for clusternode and there will be others for sure > > Yes, it would work fine under v2. In fact it's working now - you're just > getting a warning message (I hope!). We have added a lot more checks to > the configuration to try and help invalid configurations from being run > and causing trouble. when starting the cluster i get just warnings, but updating the config and using cman_tool version -r cman doesn't reload it, so i am forced to fix my errors :) > > >> If you need to specify an encrpytion key it should go into the<totem> > >> part of cluster.conf. > >> > > > > looking at cluster.rng keyfile is valid for the cman block. May i just move it > > there or i should create<totem> > > I would just remove it. It's not doing anything, so if you move it to > <totem> you will change the encryption key used by the cluster and have > to reboot all your nodes to get them communicating again. > The cluster is not a production one, so it is OK and am looking for the correct end result. My question was actually 'Is encription key valid/used only from <totem> section or in <cman> too as described in cluster.rng file'. Multicast and keyfile are present in both <cman> and <totem> ... i guess <totem> is the preferred one for future compatibility? > Chrissie > > -- > Linux-cluster mailing list > Linux-cluster@xxxxxxxxxx > https://www.redhat.com/mailman/listinfo/linux-cluster -- Linux-cluster mailing list Linux-cluster@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/linux-cluster
