That's a good question and I don't have an answer for you,
unfortunately. I just tried to reproduce it by disabling ms_bind_msgr2
for one OSD, but didn't find such log entries. Hopefully someone else
has some more insights.
Zitat von Frank Schilder <frans@xxxxxx>:
Hi Eugen,
I have found these threads and am not entirely convinced that they
apply to our situation. Most importantly, the IP addresses cannot be
clients, because they are in the replication network, which clients
don't have access to. The formulation of the message sounds a lot
like a PG peer is using v1 instead of v2. Both peers in the log
message have v1 and v2 addresses though.
The log messages with v1 clients looked different. Apart from that,
if this is normal, why the continuous log entries - why not just one
on connect? I can't get the old kernel clients to talk v2, so its
basically log spam. Let's say its the clients, I didn't see a
resolution. How can I shut off these messages?
Thanks a lot!
=================
Frank Schilder
AIT Risø Campus
Bygning 109, rum S14
________________________________________
From: Eugen Block <eblock@xxxxxx>
Sent: 17 January 2023 10:02:13
To: ceph-users@xxxxxxx
Subject: Re: ._handle_peer_banner peer [v2:***,v1:***]
is using msgr V1 protocol
Hi,
this sounds familiar, I believe this means that (some) of your clients
are using msgr_v1. I assume that your MONs are configured to use both
v1 and v2? I read somewhere that kernel clients might not support v2,
but I'm not really sure. But there are a couple of threads discussing
this.
Regards,
Eugen
Zitat von Frank Schilder <frans@xxxxxx>:
Hi all,
on an octopus latest cluster I see a lot of these log messages:
Jan 13 20:00:25 ceph-21 journal: 2023-01-13T20:00:25.366+0100
7f47702b8700 -1 --2-
[v2:192.168.16.96:6826/5724,v1:192.168.16.96:6827/5724] >>
[v2:192.168.16.93:6928/3503064,v1:192.168.16.93:6929/3503064]
conn(0x55c867624400 0x55c7e9dfa800 unknown :-1 s=BANNER_CONNECTING
pgs=22826 cs=73364 l=0 rev1=1 rx=0 tx=0)._handle_peer_banner peer
[v2:192.168.16.93:6928/3503064,v1:192.168.16.93:6929/3503064] is
using msgr V1 protocol
These addresses are on the replication network and both hosts are OSD hosts.
What is the reason for these messages and how can I fix it?
Thanks a lot!
=================
Frank Schilder
AIT Risø Campus
Bygning 109, rum S14
_______________________________________________
ceph-users mailing list -- ceph-users@xxxxxxx
To unsubscribe send an email to ceph-users-leave@xxxxxxx
_______________________________________________
ceph-users mailing list -- ceph-users@xxxxxxx
To unsubscribe send an email to ceph-users-leave@xxxxxxx
_______________________________________________
ceph-users mailing list -- ceph-users@xxxxxxx
To unsubscribe send an email to ceph-users-leave@xxxxxxx
