This works, it just says that it *might* require a restart, but this particular option takes effect without a restart. Implementation detail: this message shows up if there's no internal function to be called when this option changes, so it can't be sure if the change is actually doing anything because the option might be cached or only read on startup. But in this case this option is read in the relevant path every time and no notification is required. But the injectargs command can't know that. Paul On Mon, Apr 15, 2019 at 11:38 PM solarflow99 <solarflow99@xxxxxxxxx> wrote: > > Then why doesn't this work? > > # ceph tell 'osd.*' injectargs '--osd-recovery-max-active 4' > osd.0: osd_recovery_max_active = '4' (not observed, change may require restart) > osd.1: osd_recovery_max_active = '4' (not observed, change may require restart) > osd.2: osd_recovery_max_active = '4' (not observed, change may require restart) > osd.3: osd_recovery_max_active = '4' (not observed, change may require restart) > osd.4: osd_recovery_max_active = '4' (not observed, change may require restart) > > # ceph -n osd.1 --show-config | grep osd_recovery_max_active > osd_recovery_max_active = 3 > > > > On Wed, Apr 10, 2019 at 7:21 AM Eugen Block <eblock@xxxxxx> wrote: >> >> > I always end up using "ceph --admin-daemon >> > /var/run/ceph/name-of-socket-here.asok config show | grep ..." to get what >> > is in effect now for a certain daemon. >> > Needs you to be on the host of the daemon of course. >> >> Me too, I just wanted to try what OP reported. And after trying that, >> I'll keep it that way. ;-) >> >> >> Zitat von Janne Johansson <icepic.dz@xxxxxxxxx>: >> >> > Den ons 10 apr. 2019 kl 13:37 skrev Eugen Block <eblock@xxxxxx>: >> > >> >> > If you don't specify which daemon to talk to, it tells you what the >> >> > defaults would be for a random daemon started just now using the same >> >> > config as you have in /etc/ceph/ceph.conf. >> >> >> >> I tried that, too, but the result is not correct: >> >> >> >> host1:~ # ceph -n osd.1 --show-config | grep osd_recovery_max_active >> >> osd_recovery_max_active = 3 >> >> >> > >> > I always end up using "ceph --admin-daemon >> > /var/run/ceph/name-of-socket-here.asok config show | grep ..." to get what >> > is in effect now for a certain daemon. >> > Needs you to be on the host of the daemon of course. >> > >> > -- >> > May the most significant bit of your life be positive. >> >> >> >> _______________________________________________ >> ceph-users mailing list >> ceph-users@xxxxxxxxxxxxxx >> http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com > > _______________________________________________ > ceph-users mailing list > ceph-users@xxxxxxxxxxxxxx > http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com _______________________________________________ ceph-users mailing list ceph-users@xxxxxxxxxxxxxx http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
 |