I've crossposted the problem to the freebsd-stable mailinglist. There is no ALUA support at the initiator side. There were 2 options for multipathing: 1. Export your LUNs via two (or more) different paths (for example via two different target portal IP addresses), on the initiator side set up both iSCSI sessions in the usual way (like without multipathing), add kern.iscsi.fail_on_disconnection=1 to /etc/sysctl.conf, and set up gmultipath on top of LUNs reachable via those sessions 2. Set up the target so it redirects (sends "Target moved temporarily" login responses) to the target portal it considers active. Then set up the initiator (single session) to either one; the target will "bounce it" to the right place. You don't need gmultipath in this case, because from the initiator point of view there's only one iSCSI session at any time. Would an of those 2 options be possible on the ceph iscsi gateway solution to configure? Regards, Frank Jason Dillaman wrote: > Conceptually, I would assume it should just work if configured correctly > w/ multipath (to properly configure the ALUA settings on the LUNs). I > don't run FreeBSD, but any particular issue you are seeing? > > On Tue, Jun 26, 2018 at 6:06 PM Frank de Bot (lists) <lists@xxxxxxxxxxx > <mailto:lists@xxxxxxxxxxx>> wrote: > > Hi, > > In my test setup I have a ceph iscsi gateway (configured as in > http://docs.ceph.com/docs/luminous/rbd/iscsi-overview/ ) > > I would like to use thie with a FreeBSD (11.1) initiator, but I fail to > make a working setup in FreeBSD. Is it known if the FreeBSD initiator > (with gmultipath) can work with this gateway setup? > > > Regards, > > Frank > _______________________________________________ > ceph-users mailing list > ceph-users@xxxxxxxxxxxxxx <mailto:ceph-users@xxxxxxxxxxxxxx> > http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com > > > > -- > Jason _______________________________________________ ceph-users mailing list ceph-users@xxxxxxxxxxxxxx http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
 |