Hi David, Well, most probably the larger part of our PGs will have to be reorganized, as we are moving from 9 hosts to 3 chassis. But I was hoping to be able to throttle the backfilling to an extent where it has minimal impact on our user traffic. Unfortunately I wasn't able to do it. I saw that the newer versions of ceph have the "osd recovery sleep" parameter. I think this would help, but unfortunately it's not present in hammer ... :( Also I have an other question: Is it normal to have backfill when we add a host to a chassis even if we don't change the CRUSH rule? Let me explain: We have the hosts directly assigned to the root bucket. Then we add chassis to the root, and then we move a host from the root to the chassis. In all this time the rule set remains unchanged, with the host being the failure domain. Kind regards, Laszlo On 31.08.2017 17:56, David Turner wrote:
How long are you seeing these blocked requests for? Initially or perpetually? Changing the failure domain causes all PGs to peer at the same time. This would be the cause if it happens really quickly. There is no way to avoid all of them peering while making a change like this. After that, It could easily be caused because a fair majority of your data is probably set to move around. I would check what might be causing the blocked requests during this time. See if there is an OSD that might be dying (large backfills have the tendancy to find a couple failing drives) which could easily cause things to block. Also checking if your disks or journals are maxed out with iostat could shine some light on any mitigating factor. On Thu, Aug 31, 2017 at 9:01 AM Laszlo Budai <laszlo@xxxxxxxxxxxxxxxx <mailto:laszlo@xxxxxxxxxxxxxxxx>> wrote: Dear all! In our Hammer cluster we are planning to switch our failure domain from host to chassis. We have performed some simulations, and regardless of the settings we have used some slow requests have appeared all the time. we had the the following settings: "osd_max_backfills": "1", "osd_backfill_full_ratio": "0.85", "osd_backfill_retry_interval": "10", "osd_backfill_scan_min": "1", "osd_backfill_scan_max": "4", "osd_kill_backfill_at": "0", "osd_debug_skip_full_check_in_backfill_reservation": "false", "osd_debug_reject_backfill_probability": "0", "osd_min_recovery_priority": "0", "osd_allow_recovery_below_min_size": "true", "osd_recovery_threads": "1", "osd_recovery_thread_timeout": "60", "osd_recovery_thread_suicide_timeout": "300", "osd_recovery_delay_start": "0", "osd_recovery_max_active": "1", "osd_recovery_max_single_start": "1", "osd_recovery_max_chunk": "8388608", "osd_recovery_forget_lost_objects": "false", "osd_recovery_op_priority": "1", "osd_recovery_op_warn_multiple": "16", we have also tested it with the CFQ IO scheduler on the OSDs and the following params: "osd_disk_thread_ioprio_priority": "7" "osd_disk_thread_ioprio_class": "idle" and the nodeep-scrub set. Is there anything else to try? Is there a good way to switch from one kind of failure domain to an other without slow requests? Thank you in advance for any suggestions. Kind regards, Laszlo _______________________________________________ ceph-users mailing list ceph-users@xxxxxxxxxxxxxx <mailto:ceph-users@xxxxxxxxxxxxxx> http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
_______________________________________________ ceph-users mailing list ceph-users@xxxxxxxxxxxxxx http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
