Hi folks, I run ceph on a single node which contains 25 hard drives and each @7200 RPM. I write raw data into the array, it achieved 2 GB/s. I presumed the performance of ceph could go beyond 1 GB/s. but when I compile and ceph code and run development mode with vstart.sh, the average throughput is only 200 MB/s for rados bench write. I suspected it was due to the debug mode when I configure the source code, and I disable the gdb with ./configure CFLAGS='-O3' CXXFLAGS='O3' (avoid '-g' flag). But it did not help at all. I switched to the repository, and install ceph with ceph-deploy, the performance achieved 800 MB/s. Since I did not successfully set up the ceph with ceph-deploy, and there are still some pg at "creating+incomplete" state, I guess this could impact the performance. Anyway, could someone give me some suggestions? Why it is so slow when I run from vstart.sh? Best, Zhe -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.ceph.com/pipermail/ceph-users-ceph.com/attachments/20140702/0deb20e7/attachment.htm>
 |